Disassembly Procedures
!WARNING
STACK DRYER SLOPED FRONT MODELS
Note: The following section is exclusive to the stack dryers.
Service Panel and Switch
1.Disconnect power to the machine.
2.Remove three security screws.
Service
Lock
Remove Security Screws
3. Unlock the service lock.
To avoid risk of electrical shock, personal injury or death; disconnect power to unit before servicing.
5. Disconnect wires to service switch.
Access Cover
1.Disconnect power to unit.
2.Remove the Access Panel.
3.Locate and remove the 5/16" hex head screw located in the front of the dryer base frame. This screw secures the access cover to the base frame.
Screw
Access
Cover
Blower
Housing
4.Open the door.
5.Carefully slide the access cover down and away from the machine to disengage the cover from retaining clips on the front shroud located above the front panel goal posts.
4. Pull the service panel down.
Slide | Cover |
| Access |
Front Panel
Control Panel
Access Cover Hook
Service
SwitchWires
1.Disconnect power to the machine.
2.Remove the Access Panel.
3.Remove three security and two pozi drive screws securing the Control Panel under the Console.
50 | 16022904 Rev. 0 | ©2004 Maytag Appliances Company |