PROGRAMMING PROCEDURES
How to Use the Keypads to Program the Controls
1.The Whites & Colors keypad is used to change information in the programming codes, permitting adjustment. Pressing the keypad will change the characters by one (1). Rapid adjusting is possible by holding the keypad down.
2.The Permanent Press keypad will advance you through the programmed codes. Holding the keypad down will automatically advance through programs at a rate of one (1) per second.
3.The Delicates keypad is used to select or deselect options. This is an "OFF" or "ON" selection.
START OPERATING SET-UP
PD and PS Models (Single Load Dryer): Insert access door key, turn, and lift to remove access door.
PD Models (Stacked Dryers): Insert access panel key and turn.
PN Models: Insert service key and turn to "PROGRAM."
PR Models: Once the debit card reader is installed (according to the reader manufacturer's instructions), the
If manual
CAUTION: The console must not be opened unless power is first removed from the dryer. To access connector AA1, remove power, open console, disconnect plug on AA1, close console, apply power to dryer. The dryer is now in the
NOTE: Before proceeding please note that an owner can choose to uncrate a new commercial machine, hook it up, plug it in and have a unit which operates.
PD units are
PR and PN units are
The appliance is programmed at the factory as follows:
5 minutes dry time/quarter (Coin 1).
$1.50 dry price (Fixed cycle with top
$0.00 dry price (Fixed
GENERAL USER INFORMATION
Blank Display: This condition indicates that the appliance is inoperative.
"0" Minutes Showing in Display: This condition indicates that the appliance cannot be operated. Coins dropped during this condition will be stored in escrow, but cannot be used until normal operation is restored by opening and closing the door. If the door switch fails, recovery from this condition is impossible without service.
Warm Start - After Power Failure: After a delay of a few seconds, the appliance is restored to the state that existed at the time of power failure. "Reselect Cycle" will flash in the display. Select fabric setting to restart dryer.
Pricing
After the door is opened, following the completion of a cycle, the display indicates the cycle price (unless set for free operation). As coins or debit inputs arrive, the display will change to lead the user through the intiation of a cycle.
There are four (4) types of pricing.
58 | 16022904 Rev. 0 | ©2004 Maytag Appliances Company |