Maytag MLE/MLG23PRF Dryer Stopped with Zero Minutes Remaining Display, Cannot Enter Or, Exit

Troubleshooting Procedures

!W ARNING

To avoid risk of electrical shock, personal injury or death, disconnect power to unit before servicing, unless testing requires power.

Single Dryer Troubleshooting Guide

Dryer

Stopped with Zero Minutes Remaining

In The

Display

Open

corresponding dryer door. Did display change?

No

Unplug dryer and open doors. Check continuity of problem door switch and replace it if shorted.

Yes

The dryer door must be opened after the end of a cycle before the dryer will operate again. Dryer is operating normally.

Cannot

Enter Or	Check adjustment
Exit	of service switch
Operator	and lock.

Mode

Does door switch

open and close

properly?

No

Replace door

switch.

Check wiring and

terminations between

service switch and

control board.

			Check wiring and
			termination
	Yes		between door
		switch and control
				board.
					If problem persist,
Plug In Dryer
					replace control board.

Unplug the dryer and connector AA1. Check for continuity between the yellow wire (pin 2) and the orange wire (pin 3) coming from the service switch.

Reconnect AA1. If the

problem still exists, replace Yes the control board

Does service

switch open and close properly?

	Replace service
No
	switch

Operator

Options

Revert To

Defaults

Dryer

Runs

Without

Program

Selection

Setup operator options as	If problem
desired unplug machine for
	persists, replace
minimum 15 seconds, then
	control board
plug in the dryer.

Unplug the dryer is			Plug the dryer in . If problem still exists,
there continuity from		No	perform the single dryer diagnostics
GG2 to GG3?			program.
			Replace the control
	Yes
			board.

©2004 Maytag Appliances Company 16022904 Rev. 0 19