Maytag MDE/MDG21PDD, MDE/MDG21PRA manual Reversing Door Assembly, Door Disassembly, Front Panel

Disassembly Procedures

!WARNING

To avoid risk of electrical shock, personal injury or death; disconnect power to unit before servicing.

Reversing Door Assembly

Note: NOT ALL DOORS ARE REVERSIBLE

1.Disconnect power supply to unit.

2.Remove Door Assembly.

3.Remove the plastic hinge hole covers on the opposite side of the door opening.

4.Remove the hinges from the door itself and relocate them to the other side of the door.

5.Remount the door into the slots on the opposite side of the door opening in the front shroud and secure with one screw into each hinge.

6.Mount the plastic hinge hole covers onto the side the hinges were previously on, to cover the slots in the front shroud.

				Counter Sunk
				Screw
					Door
			Hinge		Screw
Hinge	Door
Hole	Catch
				Door
		Inner Door
Cover	Cover			Strike
		Cover Plate
					Door
					Screw

Door Disassembly

1.Disconnect power supply to unit.

2.Remove ten screws located across the bottom and along either side of the door panel. The top edge of the outer panel is folded over the inner door plug.

Front Panel

1.Disconnect power supply to unit.

2.Open the door and remove the four screws along the inside lip of the door opening.

Note: Two are located vertically on either side of the door opening. These screws secure the front panel to the front shroud assembly.

Remove

Four

Screws

3.Remove the two lower screws (T-25H Torx) securing the front panel to the lower side flanges of the cabinet assembly (If present).

Remove

Two Screws

©2004 Maytag Appliances Company 16022904 Rev. 0 39