Installation Instructions
USING FLEXIBLE METAL DUCT FOR TRANSITION VENTING
Rigid or
If flexible metal transition duct is necessary, the following directions must be followed:
•Use the shortest length possible.
•Stretch the duct to its maximum length.
•Do not crush or collapse.
•Never use flexible metal ducting inside the wall or inside the dryer.
•Avoid resting the duct on sharp objects.
•Venting must conform to local building codes.
FOR TRANSITION VENTING (DRYER TO WALL), DO:
•DO cut duct as short as possible and install straight into wall.
•DO use elbows when turns are necessary.
Elbows
DO NOT:
•DO NOT bend or collapse ducting. Use elbows if turns are necessary.
•DO NOT use excessive exhaust length. Cut duct as short as possible.
•DO NOT crush duct against the wall.
•DO NOT set dryer on duct.
25