Kenmore 110.9656 manual Remove the door assembly, Reverse hinge

1.Using a 4" (10.2 cm) clamp, connect vent to exhaust outlet in dryer. If connecting to existing vent, make sure the vent is clean. The dryer vent must fit over the dryer exhaust outlet and inside the exhaust hood. Make sure the vent is secured to exhaust hood with a 4" (10.2 cm) clamp.

2.Move dryer into its final position. Do not crush or kink vent.

3.(On gas models) Check to be sure there are no kinks in the flexible gas line.

4.Once the exhaust vent connection is made remove the corner posts and cardboard.

Check the levelness of the dryer. Check levelness first side to side, then front to back.

If the dryer is not level, prop up the dryer using a wood block.

Use a wrench to adjust the legs up or down and check again for levelness.

Remove the 6 Phillips head screws to release the outer door assembly from the inner door assembly, as indicated below. See illustration. It is important that you remove only the

6 indicated screws.

4.Lift the inner door assembly off the outer door assembly.

5.Rotate outer door 180 °.

180 °

©eel'

You can change your door swing from a right-side opening to a left-side opening, if desired.

1.Place a towel or soft cloth on top of the dryer or work space to protect the surface.

Remove the door assembly

1.Remove the 4 screws that hold the door hinge on the front panel of the dryer.

A. Dryer front panel

B. Door assembly

Lay the door assembly on a flat, protected surface with the inside (inner door assembly) facing up.

Reverse hinge

1.Use a small flat-blade screwdriver to remove 2 plug strips from the inner door. Slide the head of the screwdriver under

the plugs, being certain not to scratch the inner door surface. Lift up.

Remove the 4 screws that attach to the inner door hinge and move the hinge to the other side. Reinstall the 4 screws.

A. Door hinge

3.Reinstall plug strips on opposite side of the inner door.

4.Check for fingerprints on the glass. Clean glass if necessary.

13