Features

SECTION II

A.Dependable Microprocessor Solid State Integrated Circuitry – To eliminate as many moving parts as possible.

B.Sensor Activated Fire Extinguishing (S.A.F.E.) System – A feature, which continually monitors the basket (tumbler) for fires. In the event of a fire, a water supply to the basket (tumbler) will suppress the fire. The Phase 7 dual microprocessor controller (DMC) computer will also notify the user that a fire has taken place.

C.Program Changes are Easily Made at the Keyboard (Touch Pad) – Actual programs are viewed at the liquid crystal display (L.C.D.) startup or verification.

D.Temperature Selections – Accommodates three (3) temperature settings: “HI” , “MED” , and “LO” , each programmable to a drying temperature between 100°F (38°C) and 190°F (87°C) for radial airflow or 100°F (38°C) and 150°F (66°C) for axial airflow.

E.Cool Down – Cool down lowers the temperature in the basket (tumbler) to make the material cool enough to handle.

F.L.C.D. – Informs user of cycle status and programs; displays important diagnostic and fault codes.

G.Wrinkle Guard Program – Helps keep items wrinkle-free when they are not removed from the dryer promptly at the end of the drying and cooling cycles.

H.Diagnostics – Major circuits, including the door switch(es), microprocessor temperature sensor, heat output circuits, and more are individually monitored, allowing for precise messages of your failure.

I.Audio Alert Signal – The tone will sound at the end of a complete drying cycle at a 1-second rate for the duration programmed. It will also sound for any fault conditions at a quarter-second rate for 4-beeps. Finally, there is a 3-beep warning at the beginning of every Wrinkle Guard On Cycle, and a continuous rapid pulse is used for the entire duration of S.A.F.E. system activation.

J.Temperature Conversion Status – Temperature-related programs can be set in either Fahrenheit (°F) or Celsius (°C). ALL temperatures will automatically convert to the corresponding values (+/- 1°) when changes are made.

K.High Temperature Protection – If the Phase 7 DMC (computer) senses that the temperature in the basket (tumbler) has exceeded 180°F (82°C) for axial airflow or 210°F (98°C) for radial airflow, it will end the drying cycle, and a fault code will be displayed indicating an overheating problem.

L.RPM – The Phase 7 DMC (computer) monitors the speed of the basket (tumbler) rotation.

M.Clean Lint – This feature notifies the user when the lint access should be cleaned.

N.Language Selection – The Phase 7 DMC (computer) has the ability to display various languages.