
CONTROLS AT A GLANCE CONT.
Press "start/pause" or change your selection below.
dryness level | options |
| |
normal dry | cycle chime loud |
| remind chime ON |
regular |
|
temperature |
|
|
|
Step 4
Review Screen – The Review Screen lists the selected settings. At this point you may press Start/Pause to begin drying the load or select “Options” for further customization of the drying cycle.
Press "start/pause" or change your selection below.
dryness level | options |
| |
normal dry | cycle chime loud |
| remind chime ON |
regular |
|
temperature |
|
|
|
Step 6
Review Screen – The review screen will appear once again to verify your selections. If they are correct, press Start/Pause. If they are incorrect, press the area you would like to change.
Options |
loud end |
of cycle chime |
continue |
Step 5
Options Screen – The option choices on the left turn the options on or off. The option choices on the right show an additional screen with multiple choices. The following options may be added to cus- tomize your Sensor Dry cycle:
•“Wrinkle Prevent” - Intermittent tumble in room temperature air for up to two hours fol- lowing the dry cycle.
•“Damp Dry Chime” - Chimes when load is damp.
•“Remind Chime” - Chimes at the end of the cycle every 5 minutes for up to two hours.
•“End of Cycle Chime” - Chimes once when the selected dryness level is reached.
When the desired selections are made, touch “Continue” to see the review screen once again.
Special Note: As you use the touchscreen, if you feel you are lost, press Back or Home.
SETTING TIME DRY
| Home |
| Press "start/pause" or | ||
|
| change your | selections below. | ||
|
|
|
| ||
sensor dry |
| time | options | ||
|
| ||||
|
|
|
| 45 min | cycle chime loud |
time dry |
| air fluff |
|
| remind chime ON |
|
|
|
| ||
|
| (no heat) |
|
|
|
|
|
|
| regular |
|
|
|
|
| ||
more cycles |
| favorites |
| temperature |
|
|
|
|
| ||
|
|
|
|
|
|
Step 1
Select “Time Dry” from the Home screen. The control defaults to 45 minutes.
| Press "start/pause" or | |||
| change your selection below. |
| ||
|
| Time |
| |
| time | 45 |
|
|
45 |
|
| ||
cycle chime loud | ||||
|
| minutes | ||
|
| remind chime ON | ||
regular | continue |
|
temperature
Step 2
Press the up and down arrows to set the appro- priate number of minutes to dry the load. The time will increase or decrease in one minute increments. Press “Continue” when done.
7