Install Leveling Legs
WARNING
Excessive Weight Hazard
Use two or more people to move and install dryer.
Failure to do so can result in back or other injury.
1.To protect the floor, use a large flat piece of cardboard from the dryer carton. Place cardboard under the entire back edge of the dryer.
2.Firmly grasp the body of the dryer (not the console panel). Gently lay the dryer on the cardboard. See illustration.
Make Gas Connection
1.Remove the red cap from the gas pipe.
2.Using a wrench to tighten, connect the gas supply to the dryer. Use
A 
B
A. Flared male fitting
B.
NOTE: For LP gas connections, you must use
A combination of pipe fittings must be used to connect the dryer to the existing gas line. Shown is a recommended connection. Your connection may be different, according to the supply line type, size and location.
3. | Examine the leveling legs. Find the diamond marking. |
4. | Screw the legs into the leg holes by hand. Use a wrench to finish turning the legs until the |
A
B
D
C
diamond marking is no longer visible. |
5. Place a carton corner post from dryer packaging under each of the 2 dryer back corners. |
Stand the dryer up. Slide the dryer on the corner posts until it is close to its final location. |
Leave enough room to connect the exhaust vent. |
A. 3/8” flexible gas connector
B. 3/8” dryer pipe
C. 3/8” to 3/8” pipe elbow
D.3/8”
†®TEFLON is a registered trademark of E.I. Du Pont De Nemours and Company.
14