Raymarine 150/400 manual Install the Course Computer

Page 17

Step 3: Install the Course Computer

9

Step 3: Install the Course Computer

Installing the course computer involves these tasks:

	3.1	Select the location	page 10


	3.2	Secure the course computer	page 12


	3.3	Remove the connector cover	page 12	Step


	3.4	Attach the power cables	page 15
	3.4	Attach the power cables	page 15	3
				3

Maincover	Mountinglug
Connectorcatch
	Keyholeslot
cover
	Suppressionferrite
	Tie-wrap
Mountingscrews,	Cableclampforautopilot
	systemcomponents
No8x3/4in(x5)	andpower	D5413-2

Course computer - main parts

Image 17

Contents Type 150/400 Autopilot System Type 150/400 Autopilot System Installation Guide Contents Glossary Index MaintenanceSpecifications About this handbook Important Information WarrantySafety notices Handbook information EMC conformanceViii Read this handbook Check the Installation KitAutopilot system core pack contents Rudder position sensor CompassType 150G Type 400GAutopilot system extended systems Autopilot system other key componentsDrive unit Control unitCheck parts supplied Obtain installation toolsCourse computer components Core pack parts suppliedIdentify suitable locations D5378-1Rotary rudder position sensor location EMC installation guidelinesConnections to other equipment Suppression ferritesInstalling the course computer involves these tasks Install the Course ComputerSuitable locations Course computer installation dimensionsSelect the location Orientation Unsuitable locationsSecure the course computer Remove the connector coverMinimum Course computer inputs, outputs and fuses Replacing the connector coverUsing the fuses Connecting cables to the terminalsPower and Motor terminals Other terminalsFerr ite Attach the power cablesType 1 drive 12/24 Drive CR pump solenoids Cable length Cable gauge Copper areaType 2 drive 12 Type 2 drive 24Compass description and dimensions Install the CompassStandard location Steel-hulled boats Finding the most suitable locationConnect to the course computer Mount the compassConnecting SeaTalk or Nmea compasses Introduction Install the Rudder Position SensorRotary rudder position sensor installation Vertical alignment Ensuring correct alignmentAttaching the sensor to the tiller arm Securing the sensor to the boatHorizontal alignment Attaching the tiller pin to the tiller armChecking alignment Connecting to the course computerAttaching the connector rod Mounting Linear rudder position sensor installationConnecting to the course computer Step Install the Drive UnitType 150, 150G, 400 and 400G course computes Install the Control UnitClamp the Cables Integrate the System Possible systems Connecting SeaTalk equipmentSingle control unit, single power supply Isolated control unit, single power supply Isolated control unit, single power supplyTypical larger boat system Separate course computer and instrument powerTypical larger boat system Course computer Nmea inputs/outputs Connecting Nmea equipmentNmea 0183 received Information extracted Course computer Nmea 1 and 2 inputsSeaTalk/NMEA interface Connecting several items of Nmea equipmentControl unit Nmea inputs Option 1 without SeaTalk/NMEA interface Typical Nmea connectionsExternal alarm Connecting optional componentsGyroPlus yaw sensor Handheld remotesOther manufacturers’ drive units Off switchConnecting spool valves Course computer connections Setting-up the autopilotFault-finding MaintenanceRegular checks ServicingProduct support EMC, servicing and safety guidelinesCourse computer specifications SpecificationsControl unit functionality Course computer specifications contdControl unit Course computer Type 150G/400G Type 150/400 Type 100/300Term Meaning GlossaryVHF EMC IndexType 150/400 Autopilot System Installation Guide Index Type 150/400 Autopilot System Installation Guide Rudder position sensor template AftPage Warranty Limitations Limited Warranty CertificateUnited States of America UK, Europe, Middle East, Far East Factory Service Centers