Furuno SC-60 Initial Settings, Confirming satellite status choosing mounting method, Main menu

2. INSTALLATION

2.6Initial Settings

Follow the procedures in this section to enter initial settings.

NOTICE

Improper menu settings may stop output of data and display the message "RATE ERROR." Be sure to enter correct data.

2.6.1Confirming satellite status; choosing mounting method

1. Turn on the processor unit and press the [MENU] key to show the menu.

MAIN MENU

ALARMS

MESSAGES GPS SETUP SYS SETUP SOFT VER.

OTHERS

SATELLITE DGPS

I/O SETUP INST MENU ERASE TRIP MENU

Main menu

2. Use the Omnipad () to choose “INST MENU” and press the [ENT] key.

INSTALLATION SETUP

MOUNTING : FLOOR

DIRECTION : A

LANGUAGE : ENG

Installation setup menu

3.Confirm that “MOUNTING” is selected and press the [ENT] key.

4.Use the Omnipad to choose the mounting method: “FLOOR”, “WALL” or “INVERT” as appropriate.

5.Press the [ENT] key.

6.Choose “DIRECTION” and press the [ENT] key.

7.Use the Omnipad to choose mounting direction (“A ”, “B ”, “C” or “D”) as appropriate. Refer to section 2.3.1.

8.Press the [ENT] key.

9.Press the [SAT STATUS] key.

		Satellites used for
		measurement
	SAT TRACKING STATUS
Satellites	TIMER 5 '52"			OK
		NO. GOOD STATUS
being	GPS1	8	8	D3D
tracked	GPS2	7	7	D3D
	GPS3	8	8	D3D

"OK" displayed when the "GOOD" column shows that the number of satellites acquired is five or more.

"3D" shown when no beacon receiver is used.

Satellite tracking status display

2-19