Axis Communications YP3040 manual Warranty, Change the DIP switch settings, Select functions

Page 12 YP3040 Installation Guide

Change the DIP switch settings

1.Loosen the 4 side panel mounting screws and remove the side panel.

2.Set the 8 switches to select functions. Switches 1, 2, 3, and 4 are used to select the PTZ control protocol. Switch 7 is always OFF. Switch 8 is used to connect a terminal resistance of 120 Ω, switch to ON when required.

Select functions		1	2	3	4	5	6	7	8
Protocol	Pelco-D (default)	ON	ON	OFF	OFF
	Pelco-P	OFF	ON	OFF	OFF
	AD/AB	OFF	OFF	ON	OFF
Bit rate	2400 bps (default)					OFF	OFF
	4800 bps					ON	OFF
	9600 bps					OFF	ON
	19200 bps					ON	ON
Terminal resistance	OFF (default)								OFF
	120 Ω								ON
								OFF

3. Set the 8 switches to select address.

Select address	1	2	3	4	5	6	7	8
1 (default)	ON	OFF	OFF	OFF	OFF	OFF	OFF	OFF
2	OFF	ON	OFF	OFF	OFF	OFF	OFF	OFF
3	ON	ON	OFF	OFF	OFF	OFF	OFF	OFF
4	OFF	OFF	ON	OFF	OFF	OFF	OFF	OFF
5	ON	OFF	ON	OFF	OFF	OFF	OFF	OFF
...	.............................
254	OFF	ON	ON	ON	ON	ON	ON	ON
255	ON	ON	ON	ON	ON	ON	ON	ON

4. Replace the side panel and tighten the screws.

Warranty

For information about Axis' product warranty and thereto related information, please see: www.axis.com/warranty