Furuno CH300 manual Mounting separated monitor unit

Page 11

1. MOUNTING

Flush mounting

Flush mounting for unibody (Type: OP06-16, Code no.: 006-556-300)

Name	Type	Code No.	Qty	Remarks
Fixing metal	06-021-1311-2	100-279-612-10	1
Self-tapping screw	5x20	000-162-609-10	6
Hex. bolt	M4x12	000-162-939-10	4

1.Cut out a hole (W287 x H297) in the mounting location.

2.Fasten monitor/control unit with the fixing metal (supplied) and four hex. bolts (M4x12, supplied).

3.Fasten the fixing metal assembled at step 2 to hole made at step 1 with six self-tapping screws (5x20, supplied).

Hex. bolts

Fixing metal

1.1.3Mounting separated monitor unit

1.Fasten the mounting base to the mounting location with four self-tapping screws (5x20).

FRONT

Mounting base

2.Dismount the coupling plate to separate monitor unit from control unit.

3.Attach the bracket at rear of the monitor unit with four binding screws (M4x10).

1-3

Image 11

Contents DUAL-FREQUENCY Searchlight Sonar 00015190211 Safety Instructions Working with the Sonaroil Table of Contents System Configuration Standard Supply Equipment ListsOptions Mounting base Monitor Unit/Control UnitFastening bracket to mounting base Bracket, rear viewMounting separated monitor unit Bracket rear view Blackbox type Control UnitHex. bolts Fixing metal Transceiver unit Transceiver UnitHull Unit Installation location for hull unitTransducer tank Assembling and mounting of hull unit Trunnion pin Shaft sleeve and raise/lower drive unit assemblyTank and tank guide, sectional view Applying Cemedine High Super to main shaftInstalling shims 1800 1600 1400 1200 Tank guide attachment Installing grease cotton on the main shaft Filling the soundome with sonar oil Detaching the soundomeEmergency Paint area Mounting Checking manual raise/lower of soundome with hand crank Interface Unit Mounting considerations Motion Sensor MS-100 optionClinometer BS-704 option Wiring Among Units WiringWiring Wiring, with monitorMJ-A6SPF DPYCYS-2.5 Wiring, without monitorTransceiver unit, internal view TB1Outputting KP of CH-300 to other sonar, echo sounder Connection of transceiver unit to other sonar/echo sounderHull unit, inside view VGA NAV Available I/O sentences I/O SentencesGeneral checks General ChecksUser menu SYS Checking TX FrequencyGeneral checks con’t Test display System menuHeading offset display Heading Alignment SettingChecking heading alignment TX Rate window Setting for Synchronizing Transmission with other EquipmentMenu COM1 System setting 1 menu Setting for Satellite CompassSystem setting 2 menu Adj motion sensor menu Setting of Motion Sensor/Satellite CompassSystem Back Up System backup menuInterface unit, DIP switch S1 location Setting of Interface Unit+/05+105+0&4#9+014440%10. +/05+105+0&4#9+014440%10.#8 #%%5514+5 㩖㩡㩧㩆㩨 #8 Page Page Page Page Page Page Page Hatai This page is intentionally left blank Page Page Page Page Page Page Page Hatai Page This page is intentionally left blank Page Page Page Page Page 2周波サーチライトソナー 2周波サーチライトソナーI/Fユニット使用