Furuno CH300 manual Working with the Sonaroil

Page 4

CAUTION

Ground the equipment to prevent electrical shock and mutual interference.

Observe the following compass safe distances to prevent deviation of a magnetic compass:

 

Standard

Steering

 

 

 

CH-302/

0.80 m

0.55 m

MU-100C

 

 

 

 

 

CH-303

0.55 m

0.30 m

 

 

 

IF-8000

0.95 m

0.65 m

 

 

 

CH-302

0.30 m

0.30 m

 

 

 

CH-256

0.30 m

0.30 m

 

 

 

Install the monitor unit MU-100C out of direct sunlight.

It is difficult to see the display in direct sunlight.

Keep hands away from the raise/lower shaft of the hull unit when it is working.

Injury to hands may result if they become caught in the shaft.

Do not exceed 20 knots when operating the equipment and do not exceed 15 knots when raising or lowering the transducer.

The transducer shaft may become damaged.

The hull unit is designed to withstand ship's speed of 20 knots. For vessel with greater speed, reinforce the hull unit.

The transducer tank should be mounted at the place above the waterline. If this is impossible, make safety provisions (ex. construction of watertight compartment).

If there is a possibibility of vibration at the soundome in high-speed cruising, which creates prssure inside the tank, discuss the problem with shipyard and hull manufacturer.

ii

CAUTION

WORKING WITH THE SONAROIL

Precautions

Keep oil away from eyes. Wear protective gloves when working with the oil. The oil can cause inflammation of the eyes.

Do not touch the oil. Wear protective gloves when working with the oil. The oil can cause inflammation of the skin.

Do not ingest the oil. Diarrhea or vomiting can result.

Keep the oil out of reach of children.

Emergency

If the oil enters eyes, flush with clean water about 15 min. Consult a physician.

If the oil contacts skin, wash within soap and water.

If the oil is ingested, see a physician immediately.

Disposal of oil and its container

Dispose of oil and its container in accordance with local regulations. For further details, contact place of purchase.

Storage

Seal container to keep out foreign material. Store in dark place.

Image 4
Contents DUAL-FREQUENCY Searchlight Sonar 00015190211 Safety Instructions Working with the Sonaroil Table of Contents System Configuration Equipment Lists Standard SupplyOptions Monitor Unit/Control Unit Mounting baseBracket, rear view Fastening bracket to mounting baseMounting separated monitor unit Bracket rear view Control Unit Blackbox typeHex. bolts Fixing metal Transceiver Unit Transceiver unitInstallation location for hull unit Hull UnitTransducer tank Assembling and mounting of hull unit Shaft sleeve and raise/lower drive unit assembly Trunnion pinApplying Cemedine High Super to main shaft Tank and tank guide, sectional viewInstalling shims 1800 1600 1400 1200 Tank guide attachment Installing grease cotton on the main shaft Detaching the soundome Filling the soundome with sonar oilEmergency Paint area Mounting Checking manual raise/lower of soundome with hand crank Interface Unit Motion Sensor MS-100 option Mounting considerationsClinometer BS-704 option Wiring Wiring Among UnitsWiring, with monitor WiringWiring, without monitor MJ-A6SPF DPYCYS-2.5TB1 Transceiver unit, internal viewConnection of transceiver unit to other sonar/echo sounder Outputting KP of CH-300 to other sonar, echo sounderHull unit, inside view VGA NAV I/O Sentences Available I/O sentencesGeneral Checks General checksGeneral checks con’t Checking TX FrequencyUser menu SYS System menu Test displayChecking heading alignment Heading Alignment SettingHeading offset display Menu COM1 Setting for Synchronizing Transmission with other EquipmentTX Rate window Setting for Satellite Compass System setting 1 menuSystem setting 2 menu Setting of Motion Sensor/Satellite Compass Adj motion sensor menuSystem backup menu System Back UpSetting of Interface Unit Interface unit, DIP switch S1 location+/05+105+0&4#9+014440%10. +/05+105+0&4#9+014440%10.#8 #%%5514+5 㩖㩡㩧㩆㩨 #8 Page Page Page Page Page Page Page Hatai This page is intentionally left blank Page Page Page Page Page Page Page Hatai Page This page is intentionally left blank Page Page Page Page Page 2周波サーチライトソナー 2周波サーチライトソナーI/Fユニット使用