Furuno CH300 manual System setting 2 menu

3. ADJUSTMENT

	** SYSTEM SETTING 2 **
	: 1
MENU			2
GAIN SETTING PROTECT : OFF			ON
	: OFF
HORZ/HISTORY			ON
	: OFF
HORZ/VERT ZOOM			ON
	: OFF
HORZ/PLOTTER			ON
	: OFF			RED
EMPHASIS MODE			NORMAL
STABILIZER	: OFF				SAT. COMPASS
			MOTION SENSOR
AUTO RETRACTION	:	OFF	(OFF, 5-15 kt)
SPEED ALARM/MESSAGE :		OFF	ON
	: DOT
SWEEP INDICATOR			LINE
DEFAULT SETTING	:
		NO	YES

MAXIMUM ALLOWABLE SPEED IS 15 KNOTS WHILE SOUNDOME IS BEING RETRACTED. IF VESSEL HAS REPAID ACCELERATION CAPABILITIES, AUTO RETRACTION SETTINGS OF 10-12 KNOTS ARE MANDATORY TO AVOID CATASTROPHIC DAMAGE TO SOUNDOME ASSY. ANY PHISICAL DAMAGE TO THE SOUDOME ASSY. IS CONSIDERED ABUSE AND

IS NOT A WARRANTY ISSUE.

: SELECT : CHANGE MENU: END

System setting 2 menu

8.Press ▼ to select STABILIZER.

9.Press ► to select SAT. COMPASS.

10.Press the MENU key twice to close the menu.

Note: To output data from SC-50/110 in NMEA format, set the SC-50/110 as follows.

-Output format: IEC ed1

-Sentence: ATT (For others, set all OFF.)

-Baud rate: 38400 bps

-Cycle: 25 ms

(Talker : any)

Note: When connecting the analog signal of Satellite Compass SC-50/110 to the MOTION SENSOR port on the transceiver unit, choose MOTION SENSOR at step 9 in the above procedure. For wiring details, see the interconnection diagram at the back of this manual.

3-7