Furuno CH300 manual Hull Unit, Hull unit, inside view

Page 38

2. WIRING

2.3Hull Unit

Pass the cables to the 06P0257 Board, through the cable protectors.

J2

06P0257

Fasten glands securely by hand.

Cable from transducer

J1

J3

J1

J2

06S4081

Attach the EMI core RFC-4 (supplied)

*Noteto this cable, and then fix the core to the cable for JI with the cable tie CV-100N (supplied).

Cable from transceiver unit 06S4080

*Note

TB2 +

Power cable 250V-DPYCYS-2.5

-

*Note

06P0243

Power switch

Should always be in up position (ON).

Earth

Connect to ship's earth.

*Note: Fix the braided shield with cable clamp.

Hull unit, inside view

Attaching EMI core RFC-4

2-6

Image 38

Contents DUAL-FREQUENCY Searchlight Sonar 00015190211 Safety Instructions Working with the Sonaroil Table of Contents System Configuration Equipment Lists Standard SupplyOptions Monitor Unit/Control Unit Mounting baseBracket, rear view Fastening bracket to mounting baseMounting separated monitor unit Bracket rear view Control Unit Blackbox typeHex. bolts Fixing metal Transceiver Unit Transceiver unitInstallation location for hull unit Hull UnitTransducer tank Assembling and mounting of hull unit Shaft sleeve and raise/lower drive unit assembly Trunnion pinApplying Cemedine High Super to main shaft Tank and tank guide, sectional viewInstalling shims 1800 1600 1400 1200 Tank guide attachment Installing grease cotton on the main shaft Detaching the soundome Filling the soundome with sonar oilEmergency Paint area Mounting Checking manual raise/lower of soundome with hand crank Interface Unit Motion Sensor MS-100 option Mounting considerationsClinometer BS-704 option Wiring Wiring Among UnitsWiring, with monitor WiringWiring, without monitor MJ-A6SPF DPYCYS-2.5TB1 Transceiver unit, internal viewConnection of transceiver unit to other sonar/echo sounder Outputting KP of CH-300 to other sonar, echo sounderHull unit, inside view VGA NAV I/O Sentences Available I/O sentencesGeneral Checks General checksUser menu SYS Checking TX FrequencyGeneral checks con’t System menu Test displayHeading offset display Heading Alignment SettingChecking heading alignment TX Rate window Setting for Synchronizing Transmission with other EquipmentMenu COM1 Setting for Satellite Compass System setting 1 menuSystem setting 2 menu Setting of Motion Sensor/Satellite Compass Adj motion sensor menuSystem backup menu System Back UpSetting of Interface Unit Interface unit, DIP switch S1 location+/05+105+0&4#9+014440%10. +/05+105+0&4#9+014440%10.#8 #%%5514+5 㩖㩡㩧㩆㩨 #8 Page Page Page Page Page Page Page Hatai This page is intentionally left blank Page Page Page Page Page Page Page Hatai Page This page is intentionally left blank Page Page Page Page Page 2周波サーチライトソナー 2周波サーチライトソナーI/Fユニット使用