Furuno CH300 manual Wiring, without monitor, MJ-A6SPF DPYCYS-2.5

Page 35

Interface unit

IF-8000

Note 1

	Navigation equipment
	Max. 15m	Note 2
	External monitor	Note 2
Note 3
* a	Interface unit	External monitor
06S4078	Note 3 * b
(5/10m)
	MJ-A10SPF0002-050	CONT
06S4078	MJ-A10SPF0002-050
06S4078	(5m)	REM

	(5/10m)	Control unit
		Control unit
		CH-302	Control unit, rear view
			Control unit, rear view	(5m)
				(5m)
				Remote controller
			Transceiver unit
	SPEAKER		CH-303
	SPEAKER
	Loudspeaker	MJ-A6SPF	DPYCYS-2.5
	Loudspeaker	0012	DPYCYS-2.5	12-24VDC
	(w/cable)	0012


		Satellite
		compass		06S4081
	Ext. KP			06S4081
	Ext. KP	06S4037		(3.5/5.2m)
				(3.5/5.2m)

		(10m)
		Monitor unit
		Clinometer		12/24VDC
		06S4080(15/30/50m)		12/24VDC
		06S4080(15/30/50m)		DPYCYS-2.5
				DPYCYS-2.5

Hull unit

CH-304

CH-305

Note 1: Two interface units may be connected.

Note 2: For interface unit, the external monitor (user supply) is required.

Note 3 *a b<15m

Wiring, without monitor

2-3

Image 35

Contents DUAL-FREQUENCY Searchlight Sonar 00015190211 Safety Instructions Working with the Sonaroil Table of Contents System Configuration Standard Supply Equipment ListsOptions Mounting base Monitor Unit/Control UnitFastening bracket to mounting base Bracket, rear viewMounting separated monitor unit Bracket rear view Blackbox type Control UnitHex. bolts Fixing metal Transceiver unit Transceiver UnitHull Unit Installation location for hull unitTransducer tank Assembling and mounting of hull unit Trunnion pin Shaft sleeve and raise/lower drive unit assemblyTank and tank guide, sectional view Applying Cemedine High Super to main shaftInstalling shims 1800 1600 1400 1200 Tank guide attachment Installing grease cotton on the main shaft Filling the soundome with sonar oil Detaching the soundomeEmergency Paint area Mounting Checking manual raise/lower of soundome with hand crank Interface Unit Mounting considerations Motion Sensor MS-100 optionClinometer BS-704 option Wiring Among Units WiringWiring Wiring, with monitorMJ-A6SPF DPYCYS-2.5 Wiring, without monitorTransceiver unit, internal view TB1Outputting KP of CH-300 to other sonar, echo sounder Connection of transceiver unit to other sonar/echo sounderHull unit, inside view VGA NAV Available I/O sentences I/O SentencesGeneral checks General ChecksUser menu SYS Checking TX FrequencyGeneral checks con’t Test display System menuHeading offset display Heading Alignment SettingChecking heading alignment TX Rate window Setting for Synchronizing Transmission with other EquipmentMenu COM1 System setting 1 menu Setting for Satellite CompassSystem setting 2 menu Adj motion sensor menu Setting of Motion Sensor/Satellite CompassSystem Back Up System backup menuInterface unit, DIP switch S1 location Setting of Interface Unit+/05+105+0&4#9+014440%10. +/05+105+0&4#9+014440%10.#8 #%%5514+5 㩖㩡㩧㩆㩨 #8 Page Page Page Page Page Page Page Hatai This page is intentionally left blank Page Page Page Page Page Page Page Hatai Page This page is intentionally left blank Page Page Page Page Page 2周波サーチライトソナー 2周波サーチライトソナーI/Fユニット使用