Furuno CH300 manual Setting for Synchronizing Transmission with other Equipment, Menu COM1

Page 45

3. ADJUSTMENT

3.4Setting for Synchronizing Transmission with other Equipment

To synchronize transmission with other echo sounder (see paragraph 2.2), do as follows:

1.Press the MENU key to display the menu.

2.Press ◄ to select COM1 at the top of menu display.

	MENU	COM1 COM2	HORZ VERT ES PRESET SYS
	TX POWER	MAX
	PULSELENGTH	LONG
	TX RATE	10
	INT REJECT	OFF
	AGC	OFF
	AUDIO LEVEL	0


	: SELECT	: CHANGE	MENU: END

Menu (COM1)

3.Press ▼ to select TX RATE.

4.Press ► to display the setting window.

TX RATE

EXT. MIN

5

MAX

(EXT., 1-10)

TX RATE window

5.Press ◄ several times to select EXT.

6.Press the MENU key to close the menu.

3-5

Image 45

Contents DUAL-FREQUENCY Searchlight Sonar 00015190211 Safety Instructions Working with the Sonaroil Table of Contents System Configuration Standard Supply Equipment ListsOptions Mounting base Monitor Unit/Control UnitFastening bracket to mounting base Bracket, rear viewMounting separated monitor unit Bracket rear view Blackbox type Control UnitHex. bolts Fixing metal Transceiver unit Transceiver UnitHull Unit Installation location for hull unitTransducer tank Assembling and mounting of hull unit Trunnion pin Shaft sleeve and raise/lower drive unit assemblyTank and tank guide, sectional view Applying Cemedine High Super to main shaftInstalling shims 1800 1600 1400 1200 Tank guide attachment Installing grease cotton on the main shaft Filling the soundome with sonar oil Detaching the soundomeEmergency Paint area Mounting Checking manual raise/lower of soundome with hand crank Interface Unit Mounting considerations Motion Sensor MS-100 optionClinometer BS-704 option Wiring Among Units WiringWiring Wiring, with monitorMJ-A6SPF DPYCYS-2.5 Wiring, without monitorTransceiver unit, internal view TB1Outputting KP of CH-300 to other sonar, echo sounder Connection of transceiver unit to other sonar/echo sounderHull unit, inside view VGA NAV Available I/O sentences I/O SentencesGeneral checks General ChecksChecking TX Frequency General checks con’tUser menu SYS Test display System menuHeading Alignment Setting Checking heading alignmentHeading offset display Setting for Synchronizing Transmission with other Equipment Menu COM1TX Rate window System setting 1 menu Setting for Satellite CompassSystem setting 2 menu Adj motion sensor menu Setting of Motion Sensor/Satellite CompassSystem Back Up System backup menuInterface unit, DIP switch S1 location Setting of Interface Unit+/05+105+0&4#9+014440%10. +/05+105+0&4#9+014440%10.#8 #%%5514+5 㩖㩡㩧㩆㩨 #8 Page Page Page Page Page Page Page Hatai This page is intentionally left blank Page Page Page Page Page Page Page Hatai Page This page is intentionally left blank Page Page Page Page Page 2周波サーチライトソナー 2周波サーチライトソナーI/Fユニット使用