How to attach N-P-8DFB connector (for extension cable kit)
Outer Sheath | Dimensions in millimeters. | |
Armor | Inner Sheath Shield | |
| 50 | 30 |
Cover with
Remove outer sheath and armor by the dimensions shown left.
Expose inner sheath and shield by the dimensions shown left.
Cut off insulator and core by 10 mm.
30 | 10 |
Twist shield end.
Flat Washer
Slip on clamping nut, flat washer, gasket and clamp as shown left.
Clamping Gasket Clamp
Nut (reddish
brown)
Aluminum Foil
Fold back shield over clamp and trim.
Trim shield here.
Insulator
Trim aluminum tape foil here.
Cut aluminum foil at four places, 90° from one another.
Washer 2
Fold back aluminum foil onto shield and trim.
Remove insulator up to edge of washer 2.
5
Pin
Clamping Nut
Spacer
Housing
Expose the core by 5 mm.
Slip the pin onto the conductor. Solder them together through the hole on the pin.
Insert the spacer and housing. Screw the clamping nut into the housing.
Solder through the hole.
(Tighten by turning the clamping nut. Do not tighten by turning the housing.)
How to attach
24