EVENT=Clear
EVENT=Null
<LOCATION>
LOCATION=1
LOCATION=2
LOCATION=3
LOCATION=4
LOCATION=5
LOCATION=6
LOCATION=7
LOCATION=8
LOCATION=9
LOCATION=10
LOCATION=11
LOCATION=12
LOCATION=13
LOCATION=14
LOCATION=15
LOCATION=16
<EVENT>
EVENT=String
Return Values
The command will return the updated condition of the pin in the same format as the command. If the command did not alter the state, the command returns the current event for which the pin is programmed.
Pin will execute string when actuated Parameter to return the current programming for the pin
Parameter to clear current programming (do nothing state)
EVENT LIST: AA, AD, AGC, CHAIRO, EQ, GAIN, GMODE, LFP,
MUTE, PRESET, TE
PEVNT
This command programs or returns the program of the GPIO status pins from the serial port. The command line follows the same format as shown in the PCMD example (previous page).
[DEVICE] PEVNT <LOCATION> <EVENT>
Explanation
Status pin 2 active Status pin 2 inactive Status pin 4 active Status pin 4 inactive Status pin 6 active Status pin 6 inactive Status pin 8 active Status pin 8 inactive Status pin 10 active Status pin 10 inactive Status pin 12 active Status pin 12 inactive Status pin 14 active Status pin 14 inactive Status pin 16 active Status pin 16 inactive
62 | Appendices ~ Appendix E: Serial Commands |
✍ | Preset | Command | Note: |
PRESET | has two | status |
parameters which can be set in a PEVNT command line: preset and NOT preset. To indicate NOT preset, add “!” to the end of the string. For example, this could be used to show when PRESET 1 occurs and then shut off if any other preset is selected. You would enter PRESET 1 in the active location and PRESET 1! in the inactive location for the desired pin.