Kolpak DA-98 manual Locating to a function key memory, Repeat function, To start repeat play

1)(Func)GoLtoomenu.atePncti1grouponKey)o107,smovei:04:titheon2cursor3:15ABSto Loc

,and press ENTER:

2)Move the cursor to the function key number, and use the UP and DOWN keys to select the number of the function key memory that you want to change.

3)Use the LEFT and RIGHT keys to select the field (hours, minutes, seconds or frames) and use the UP and DOWN keys to change the value of the field.

There is an “invisible” field to the right of the number. Moving the cursor to this field and press- ing the UP and DOWN keys will “fine-tune” the whole time value.

8.2.3 Locating to a function key memory

Once a location has been assigned to a function key, this is the procedure for location to the mem- ory position:

1) Press the SHIFT key.

The SHIFT indicator will start to blink.

2)Press the function key corresponding to the memory to which you want to locate.

The display will show the location point and the pre-roll time, and the tape will start to locate to the appropriate location memory.

Section 8 – Advanced operations

If you have pressed the AUTO PLAY key [ 2]

bfore pressing the SHIFT key in step 1, (the AUTO PLAY indicator is on), replay will start automati- cally when the location point is reached.

8.2.5 Repeat function

You can repeat playback continuously between Memo2the two l cation emory points (Memo1and

).

NOTE

When we talk ab ut the “first” and the “second” loca- tions here, we are referring to the earlier and later loca- Memo2tion times. Memo1could be at a later time than

,and hence we would refer to it in this sec- tion as the “second location point”.

The tape will wind to a little before the first point (if it is not there already) and start playing. The off-tape monitoring will start at the first memory location and continue until the second location is reached. The tape will then stop playing, and rewind to a little before the first point and start playing again.

8.2.6 To start repeat play

1)When the two location points have been set, press the REPEAT key [21] .

2)The tape will locate to the first location point and start playing until the second location point, rewind to the first location point, and play again. This process will be repeated.

While the tape position is between the two location points, the REPEAT indicator will be lit steadily. It will flash while the tape position is outside the two location points.

3)To use the function keys for their preset functions as written on the front panel, press SHIFT again so that the SHIFT indicator goes out.

8.2.4 Location and playback

If you press the PLAY key while the tape is locat- ing (the PLAY key will flash), the tape will start playing when it reaches the location point.

If you press PLAY twice while the tape is locating, the PLAY key will light steadily, the tape will stop and playback will start immediately.

3) Stop the repeat function by pressing the REPEAT key.

The REPEAT indicator will go out.

If the tape is playing, it will continue playing (past the second location point).

06/97 – 1.00 – 8-3