21
SERVICING / REPLACEMENTS
GLASS/DOOR REPLACEMENT
The glass door is secured at the top front edge of the fireplace. Pull the latch forward then lift hook out from slot in the door. Tilt door forward then lift out from retainer along the bottom edge of the fi replace.
1. Place the door frame face down careful not to scratch the paint.
2. Center the gasketed glass inside the door frame with the thick side of the gasket facing up.
3. Bend the glass retainers located along the edge of the door frame over the gasket holding the glass in place. Careful not to break the glass.
FIGURE 48
NOTE: Care must be tak- en when removing and disposing of any broken glass or damaged components.
Be sure to vacuum up any broken glass from inside the fi replace before operation.
BLOWER REPLACEMENT
Your 
comes equipped with a heat circulating blower. The blower is
Drywall dust will penetrate into the blower bearings, causing irreparable damage. Care must be taken to prevent drywall dust from coming into contact with the blower or its compartment. Any damage resulting from this condition is not covered by the warranty policy.
1.Turn off the power to the fi replace.
2. Turn off the gas valve. | FIGURE 49 |
BLOWER
MOUNTING PLATE
REMOVE 4 SCREWS
3.Remove the glass door, logs, rear log supports, brick panels, air defl ector, burner assy, panel support, panel support bracket.
4.The blower mounting plate can now be removed. Remove the four screws that secure the plate to the fi rebox base.
5.The blower is secured to the fi rebox. Disconnect the wire connec- tors before attempting to remove the blower from the fi rebox.
6.Remove the two screws securing the blower and lift through blower access opening.
Note: When 
replacement blower, it will be necessary to replace the gasket
FIGURE 50
BURNER AND VALVE REPLACEMENT
1a. Rectangular Front Removal
Pull on the top of the optional front away from the fi replace until the male portion of the latch disengages. Tilt forward slightly and lift from the 2 shoulder screws near the bottom.
1b. Heritage and Wrought Iron Front Removal
Turn the head of each turn button from a horizontal position to verti- cal. Allow the front to tilt forward slightly and lift from the 2 shoulder screws near the bottom front. Note: Fronts are heavy so when the second turn button is turned the front will want to fall forward. See Figure 51.
2. Control Panel Removal
Tilt control panel away from the door and lift from slots. See Figure 53.
FIGURE 51
3.Turn Power and Gas off to the unit.
4.Door Removal.
See door removal section.
5. Burner Removal
Start by removing the logs being careful since the logs may still be warm. Remove the 2 screws holding the air defl ector (Figure 52a) then remove the 3 screw holding the burner (Figure 52b). Lift burner from fi rebox.
AIR | FIGURE 52a |
| |
DEFLECTOR |
|
BURNER
FIGURE 52b
6.Remove the 5 screws securing the burner base. Once the gas has been disconnected, the valve train assembly will lift out. Service components as required.
REMOVE 2 SCREWS