FireplaceXtrordinair 864 HH Gas Line Requirements, Fuel, Gas Line Connection, Gas Inlet Pressure

Page 17

Installation (for qualified installers only)

17

Gas Line Requirements

MASSACHUSETTS INSTALLATIONS - WARNING:

THIS PRODUCT MUST BE INSTALLED BY A LICENSED PLUMBER OR GAS FITTER WHEN INSTALLED WITHIN THE COMMONWEALTH OF MASSACHUSETTS.

OTHER MASSACHUSETTS CODE REQUIREMENTS:

Flexible connector must not be longer than 36 inches.

Shutoff valve must be a “T” handle gas cock.

Only direct vent sealed combustion products are approved for bedrooms or bathrooms.

Fireplace dampers must be removed or welded in the open position prior to the installation of a fireplace insert or gas log.

A carbon monoxide (CO) detector is required in the same room as the appliance.

The gas line must be installed in accordance with all local codes, if any; if not, follow ANSI 223.1 and the requirements listed below.

The fireplace and gas control valve must be disconnected from the gas supply piping during any pressure testing of that system at test pressures in excess of 1/2 psig. For pressures under 1/2 psig, isolate the gas supply piping by closing the manual shutoff valve.

Leak test all gas line joints and the gas control valve prior to and after starting the fireplace.

Fuel

This fireplace is designed either for natural gas or for propane (but not for both). Check the sticker on the top of the gas control valve to make sure the correct fuel is used.

Gas Line Connection

Installation must be performed by a qualified installer, service agency or the gas supplier (In Massachusetts a licensed plumber/gasfitter).

Gas Inlet Pressure

Standard Input Pressure

Minimum Input Pressure

Maximum Input Pressure

 

 

 

 

 

 

 

Natural Gas

7" W.C. (1.74 kPA)

3.5" W.C. (0.87 kPA)

13.85" W.C. (3.45 kPA)

Propane

13" W.C. (2.73 kPA)

8" W.C. (1.99 kPA)

14" W.C. (3.48 kPA)

If the pressure is not sufficient, make sure the piping used is large enough, the supply regulator is adequately adjusted, and the total gas load for the residence does not exceed the amount supplied.

The supply regulator (the regulator that attaches directly to the residence inlet or to the propane tank) should supply gas at the suggested input pressure listed above. Contact the local gas supplier if the regulator is at an improper pressure.

© Travis Industries

4080214

100-01182_003

Image 17
Contents HH Fireplace Listing Details OverviewIAS Icbo Approval Massachusetts ApprovalTable of Contents Safety Warnings Safety PrecautionsSafety Precautions Dimensions Installation OptionsHeating Specifications Recommended Installation Procedure Installation OverviewPacking List Additional Items RequiredRequirements for the Commonwealth of Massachusetts Massachusetts RequirementsConverting Fireplace to Top Vent Configuration Top Vent or Rear Vent ConfigurationDo not Over Tighten Screws Converting the Fireplace to Top VentRaised Fireplaces Fireplace Placement RequirementsClearances Minimum 49 Fireplace Enclosure Height Minimum Framing Dimensions Rear Vent ConfigurationMinimum Framing Dimensions Top Vent Configuration Nailing Brackets TOP ViewCorner Installations Rear Vent Configuration Corner Installations Top Vent Configuration Fuel Gas Line RequirementsGas Line Connection Gas Inlet PressureLeft Side Gas Inlet preferred Gas Line LocationElectrical Connection required Wall Switch Installation Wall Switch or Thermostat InstallationWiring Diagram Millivolt System Altitude Considerations Vent RequirementsVent Clearances Approved Vent Vent InstallationRestrictor Position Approved Vent ConfigurationsExhaust Restrictor Adjustment Intake Restrictor Adjustment Diffuser Side View Diffuser Plate AdjustmentExhaust Restrictor Removal 0feet 5feet 22 max Feet 10feet 15feet Rear Vent Configuration with Vertical Termination Feet 21 max 5feet 10feet 15feet Top Vent Configuration with Horizontal TerminationTop Vent Configuration with Vertical Termination Termination Requirements Floor Mounted Fireplaces Hearth RequirementsFacing Requirements Drywall InstallationFacing Overview Optional Faceplates Sizing ChartFront View Raised Fireplace with no Hearth Front View Thick Facing with Fireplace Xtrordinair FPX Arched Faces Floor-Mounted Fireplace with Hearth Thick Facing Installation SideMantel Requirements Side View Installation Example Build-In with Horizontal Termination Pilot Flame Inspection Steps for Finalizing the InstallationStarting the Pilot Flame Air Shutter Adjustment Finalizing the Installation for qualified installers onlyRe-Attaching the Glass Frame Glass Frame Removal and InstallationFinalizing the Installation for qualified installers only Fireback and Grate Installation Right Log Installation Log Set InstallationRear Log Installation Left Log Installation Verify Rear LOG Position Right Twig InstallationEmber Installation Center Twig InstallationFront Twigs Installation LP Conversion Instructions Follow the directions below to replace the orifices Slotted Screwdriver Or T-20 Torx Upper Grill Installation Grill InstallationOption # 2 Remote Thermostat Remote Control Receiver Installation 2 OptionsOption # 1 Remote Thermostat Special Instructions for 864 HH Extra Room Power Heat Duct skuNew Wire Hook-Up Length = Installation OverviewMaximum Duct Length Duct Installation InstructionsFloor Mounting Attach the grill and wall adapter, if necessary Follow the directions below to wire the blower box Wiring Diagram -864TRVOFF Operating InstructionsAccent Light Installation sku Optional Equipment for qualified installers only Accent Light Operation Optional Wall-Mounted RheostatOptional Equipment for qualified installers only Index 68Index