Finalizing the Installation (for qualified installers only) | 47 |
Fireback and Grate Installation
WARNING: Firebacks are required for this fireplace and must be installed prior to operation.
1Remove the glass frame.
3Remove the exhaust restrictor (see page 23). Make sure to return the restrictor to the correct position after the firebacks are in place.
4Install the firebacks and grate following the directions below.
aRemove the screws and clips on both sides.
5/16" Nutdriver
d |
Place the floor firebacks in place.
bPlace the rear fireback in place. The side fireback holds the rear fireback in place -
hold the rear fireback while installing the side fireback.
c Place the side firebacks in place. Secure using the screws and clips removed in step “a”.
Place the grate in place. Take care to prevent it from damaging the ceramic firebacks.
© Travis Industries | 4080214 |