Heat & Glo LifeStyle 8000TRD manual Wiring the Fireplace, Optional Accessories

3/16” PIGGYBACK CONNECTOR

BLACK S2	REMOTE SWITCH
	PIGTAIL
ON
OFF

	WHITE T2	ON/OFF
		SWITCH
GAS VALUE	RED T1
	THERMOPILE
THERMOCOUPLE		OPTIONAL WALL SWITCH,
	BLACK S1
		THERMOSTAT OR REMOTE
Figure 37. Standing Pilot Ignition Wiring Diagram

Step 8. Wiring the Fireplace		Optional Accessories
NOTE: Electrical wiring must be installed by a licensed		Optional fan and remote control kits require that 110-120
electrician.		VAC be wired to the factory installed junction box before
CAUTION: DISCONNECT REMOTE CONTROLS IF AB-		the fireplace is permanently installed.
		Wall Switch
SENT FOR EXTENDED TIME PERIODS TO PREVENT
ACCIDENTAL FIREPLACE OPERATION.		Position the wall switch in the desired position on a wall.
For Standing Pilot Ignition Wiring		Run a maximum of 25 feet (7.8 m) or less length of 18
		A.W.G. minimum wire and connect it to the fireplace ON/
Appliance Requirements		OFF switch pigtails.
• This appliance DOES NOT require 110-120 VAC to operate.
		!	WARNING: DO NOT CONNECT 110-120 VAC
			TO THE WALL SWITCH OR THE CONTROL
	WARNING: DO NOT CONNECT 110-120 VAC
!			VALVE WILL BE DESTROYED.
	TO THE GAS CONTROL VALVE OR THE AP-
	PLIANCE WILL MALFUNCTION AND THE	CAUTION: LABEL ALL WIRES PRIOR TO DISCONNEC-
	VALVE WILL BE DESTROYED.	TION WHEN SERVICING CONTROLS. WIRING ERRORS
		CAN CAUSE IMPROPER AND DANGEROUS OPERATION.
		VERIFY PROPER OPERATION AFTER SERVICING.

BLK

VARIABLE SPEED CONTROL

BLK

JUNCTION BOX

NOTE: IF ANY OF THE ORIGINAL WIRE AS SUPPLIED WITH THE APPLIANCE MUST BE REPLACED, IT MUST BE REPLACED WITH TYPE 105OC RATED WIRE.

BLK

BLK

TEMPERATURE SENSOR SWITCH

BLK
	BLK
BLK
WHT	WHT
BLK
GROUND
GRN
BLK	WHT
110-120 VAC

BLOWER RECEPTACLE

	BLOWER
JUNCTION BOX	TEMPERATURE
	SENSOR SWITCH

FAN

SPEED CONTROL (RHEOSTAT)

Figure 38. Fan Wiring Diagram

28