Heat & Glo LifeStyle 8000TRD manual Operation using Battery Power

	TRANSFORMER
TRANSFORMER OUTLET	3V
	T	120 VAC
	R	JUNCTION BOX
	A		IGNITOR
	N
			MODULE
	3 S
	V F		3V
	O
	R

PLUG-IN	M
	E
3V TRANSFORMER	R	REM FAN

SPARK TO

PILOT IGNITOR

BLACK (IGNITOR)

BLACK (SENSOR)

BLACK

LOW VOLTAGE

SEE NOTE 1

IGNITION MODULE (3V)

ON/OFF

WALL SWITCH

VALVE

FLAME SPARKER /

SENSOR

OPTIONAL BATTERY BACK-UP

LOW VOLTAGE

SEE NOTE 1

ON/OFF SWITCH

BLACK

OPTIONAL

BATTERY

BACK-UP

RED

BROWN

BROWN

	PILOT ASSEMBLY
	AND VALVE ASSEMBLY
	MUST BE GROUNDED
GROUND TO
	(COMMON GROUND
FIREPLACE	WITH FIREPLACE
CHASSIS	CHASSIS)

ORANGE

	GROUND	REMOTE
NEUTRAL		CONTROL
		HOT

GREEN

NOTE 1: Ignition module, valve, pilot and wall switch operate on 3 volts. 120 VAC is required at junction box unless equipped with battery back-up.

Figure 39. Intermittent Pilot Ignition (IPI) Wiring Diagram

Intermittent Pilot Ignition (IPI) Wiring

3 Volt Transformer

This appliance comes with a 3 volt transformer found in the manual bag. Plug the transformer leads to the green con- trol module (see Figure 39). Then plug the transformer into the side outlet on the junction box.

Appliance Requirements

This appliance requires that 110-120 VAC be wired to the factory installed junction box. Maintain correct polarity when wiring the junction box.

!WARNING: DO NOT CONNECT 110-120 VAC TO THE GAS CONTROL VALVE OR THE AP- PLIANCE WILL MALFUNCTION AND THE VALVE WILL BE DESTROYED.

Operation using Battery Power

This fireplace has an optional battery operation. The sys- tem is fully functional with the use of two “D” size batteries without ordinary 110-120 VAC power.

Wiring to the battery pack should be left disconnected in order to conserve battery life. In the case of a loss of power,

simply connect red and black wire leads to activate battery power (connect red to red, black to black). The fireplace can be used as necessary. Once power (110 VAC) is re- stored, disconnect red and black wire leads to extend bat- tery life.

Optional Accessories

Optional remote control kits require that 110-120 VAC be wired to the factory installed junction box before the fire- place is permanently installed.

Wall Switch

Position the wall switch in the desired position on a wall. Run a maximum of 25 feet (7.8 m) or less length of 18 A.W.G. minimum wire and connect it to the fireplace ON/ OFF switch pigtails.

!WARNING: DO NOT CONNECT 110-120 VAC TO THE WALL SWITCH OR THE CONTROL VALVE WILL BE DESTROYED.

CAUTION: LABEL ALL WIRES PRIOR TO DISCONNEC- TION WHEN SERVICING CONTROLS. WIRING ERRORS CAN CAUSE IMPROPER AND DANGEROUS OPERA- TION. VERIFY PROPER OPERATION AFTER SERVICING.

29