Continuous Pilot Feature

Chateau™ Direct Vent Gas Fireplace

��

To Change the Set Temperature

Press and hold the SET key until the desired set tem- perature is reached. (By pressing and holding the set key, the LCD screen set numbers will increase from 45° to 99°, then restart at 45°)

Release the SET key. The LCD screen will display the set temperature for 3 seconds, then will ﬂash the set tem- perature for 3 seconds, then the LCD screen will default to display the room temperature.

To Disengage Thermostatic Mode

Press and release the MODE key or press the OFF CONTINUOUS PILOT key to disengage the thermostatic mode. The word “ROOM” on the LCD screen will not show when the thermostatic mode is not in operation.

NOTE: The highest SET temperature is 99° Fahrenheit (32° Celsius) and the lowest temperature is 45° Fahren- heit (6° Celsius).

This feature allows you to change from a spark to pilot system to a standing pilot system for appliances during Cold Climate to keep the ﬁrebox warm.

To operate the CONTINUOUS PILOT FEATURE do the following:

On or Off Operation

Press and hold the OFF CONTINUOUS PILOT key for approximately 5 seconds, until the word “PILOT” appears on the LCD screen.

NOTE: The word “PILOT” will appear on the LCD screen in ON mode.

CP (CHILDPROOF) FEATURE

This SKYTECH remote control includes a CHILDPROOF “LOCK-OUT” feature that allows the user to “LOCK-OUT” operation of the appliance from the transmitter.

SETTING “LOCK-OUT” - (CP)

•To activate the “LOCK-OUT” feature, press and hold the ON H/L key and the MODE key at the same time for 5 seconds. The letters “CP” will appear in the TEMP frame on the LCD screen.

•To disengage the “LOCK-OUT”, press and hold the ON H/L key and the MODE key at the same time for 5 seconds and the letters “CP” will disappear from the LCD screen and the transmitter will return to its normal operating condition.

•To verify the transmitter is in the CP lock-out mode, press any key and the LCD screen will show “CP”.

NOTE: If the appliance is already operating in the ON or THERMOSTATIC modes, engaging the “LOCK-OUT” will not cancel the operating mode. Engaging the “LOCK-OUT” prevents only the manual operation of the transmitter. If in the auto modes, the THERMOSTATIC operation will continue to operate normally. To totally “LOCK-OUT” the operation of the transmitter’s operating signals; the transmitter’s mode must be set to OFF.

20011957