Glass Information, Glass Cleaning | Vermont Casting DVT38S2IN

Chateau™ Direct Vent Gas Fireplace

Operating Instructions

Glass Information

Only glass approved by CFM Corporation should be used on this ﬁreplace.

•The use of any non-approved replacement glass will void all product warranties.

•Care must be taken to avoid breakage of the glass.

•Do not operate appliance with glass front removed, cracked or broken.

•A replacement glass frame assembly (complete with gasket) is available through your CFM Corporation dealer and should only be installed by a licensed qualiﬁed service person.

��

Glass Frame Assembly Removal

1.Turn the ﬁreplace OFF (including the pilot).

2.If the unit has been operating allow time for the components to cool.

3.Using a Phillips screwdriver, unfasten two (2) screws located at the top of the glass frame. (Fig. 39)

4.Tilt the glass frame at the top away from the unit. Lift it carefully off the bottom door track and set on padded surface.

Phillips

Screws

FP1800

Fig. 39 Remove Phillips screws, tilt frame forward and lift off bottom door track.

Glass Cleaning

It is necessary to periodically clean the glass. During start-up, condensation, which is normal, forms on the inside of the glass. This condensation causes lint, dust and other airborne particles to cling to the glass surface.

Also initial paint curing may deposit a slight ﬁlm on the glass. It is therefore recommended the glass be cleaned two or three times with a non-ammonia based household cleaner and warm water (gas ﬁreplace glass cleaner is recommended) within the ﬁrst few weeks of operation.

After the initial cleaning process the glass should be cleaned two or three times during each operating season depending on the environment in the house.

Clean the glass after the ﬁrst two weeks of operation.

Ceramic Refractory Installation

The ceramic refractories are fragile and should be handled with care. Due to the size of the refractories, an assistant may be helpful.

Refractory,

Left Side

Right Side

FP1580a

Fig. 40 Ceramic refractory panels.

1.Using a Robertson screwdriver, remove the two (2) nuts holding each fettle to the burner assembly.

2.Identify the side refractory. The refractory with the small cut out at the bottom must be installed on the side where the plumbing for the pilot and manifold are. The other side refractory has a larger cut out at the bottom. This is designed to allow the opening for the fresh air coming to the combustion chamber unobstructed. (Fig. 40)

3.Start with either the right side refractory or left side refractory. Hold the refractory at an angle. Slide and seat the bottom edge toward the bottom of the

20011957