joints as described on Page 16.
Sealing firestop gaps with high temperature sealant will restrict cold air being drawn in around fire- place.
STEP 6
Before installing the termination, a 2” (51 mm) thick trim or frame is required around the 16¹⁄₄” x 16¹⁄₄” (413 x 413
mm)square opening to allow the vent termination to go directly onto the elbow. (Fig. 24)
Chateau™ Direct Vent Gas Fireplace
•The control housing must only be installed on an inside wall.
Package contents:
• | 1, Glass frame assembly | • | 2, short machine screws |
• | 2, Short top brackets | • | 2, Long machine screws |
• | 2, Long bottom brackets | • | 4, sheet metal screws |
Installation Procedure
1. If the fireplace is installed flush with the wall, a high |
temperature sealant must be applied to seal around |
2” 
(51mm)
1”
(25mm)
Min.
16¹⁄₄” x 16¹⁄₄”
(413 x 413mm) Opening
1” (25mm) Min.
FP1461
the surround around the glass frame assembly 3/4” |
(19 mm) from the front edge of the surround. (Fig. |
25) |
Glass Frame As- sembly
High Temperature
Sealant
3/4"
(19mm)
Fig. 24 A 2” (51mm) thick trim is required around opening.
STEP 7
Guide the vent terminations 8” and 11” collars into their respective vent pipes. Double check that the vent pipes overlap the collars by 2” (51 mm). Secure the termina- tion to the wall with screws provided and caulk around the wall plate to weatherproof. (Fig. 24) As an alterna- tive to screwing the termination directly to the wall you may also use expanding plugs or an approved exterior construction adhesive.
Installing the 38S2VDK Door
When installing the DVT38S2 on an outside wall, the following steps must be taken into consideration. Fail- ure to do so will result in a major reconstruction and CFM Corporation will not be responsible for costs associated with incorrect installation.
•If the fireplace is to be installed flush with the wall, a 1/4” (6 mm) clearance is required on both sides and top of surround around the glass frame assembly in order for the door to be accessible. (Refer to Page 4, Fig. 1)
•If the fireplace is recessed 3/4” (19 mm) from the wall, then no extra clearances are needed around the surround.
•The fireplace must be installed with the stationary glass facing the outside (control housing will be located on the left hand side of the fireplace when facing the fireplace from inside the house).
Surround
FP1480
Fig. 25 Apply high temperature sealant on surround around glass frame assembly when unit is installed flush with wall.
2.Install the two (2) bottom (longer) brackets, using sheet metal screws, at the bottom right and left cor- ners of the unit. (Fig. 26)
Short Top
Bracket
Sheet
Metal
Screws
Refer to
Figure xx
Existing
Door on
Unit
Sheet Metal
Screws 
Long Bottom
Bracket
FP1481
Fig. 26 Use sheet metal screws to attach brackets to existing holes under glass frame assembly.
20011957 | 21 |