12.2 Soft Dry Operation
•Soft Dry operation can be set using remote control.
•Soft Dry operation is applied to dehumidify and to perform a gentle cooling to the room.
•This operation starts when the intake air temperature sensor reaches the setting temperature on the remote control.
•When operation begins, Soft Dry will be switched “ON” for a maximum 10 minutes, then Soft Dry operation will be turn “OFF” for a minimum 6 minutes. After that, the Soft Dry operation will be “ON” and “OFF” based on the setting temperature as shown in figure below.
•However after 3 minutes of compressor off, during Soft Dry “OFF” (within 6 minutes Soft Dry restart control), the indoor unit will start to operate at normal Cooling mode if the intake temperature is higher than Cooling “ON” point.
12.2.1Soft Dry Operation Time Diagram
30