A&D TM-2430-13 instruction manual Connecting the UA-767PC to the computer

Step 3 The display on the monitor will show “----”. If “----” does not appear, see “3-2

Communication Errors”. Otherwise go to step 4.

Note: If possible, keep the cable connected to the computer unless the port is needed for other functions.

Step 4 Run the software.

Step 5 Confirm that the correct serial port and the correct monitor type are set. For details, see “2-9-4-2 Serial Port” and “2-9-4-3 Recorder Type”.

2-2-3 Connecting the UA-767PC to the computer

♦You must use the A&D-supplied RS-232C communication cable, otherwise communication errors will occur.

♦You must use AX-KO1502 cable for 9 pin serial port (supplied) or AX-KO1503 cable for 25 pin serial port (available separately as an option).

Figure 3: Connection between the UA-767PC and the computer

(The illustration above is not to scale.)

Step 1 Connect the male end of the A&D-supplied RS-232C communication cable to the monitor.

Step 2 Connect the female end of the A&D-supplied RS-232C communication cable to the computer.

Step 3 After the connection, the display on the monitor will not change. The display will show “----”, just before starting communication.

Note: If possible, keep the cable connected to the computer unless the port is needed for other functions.

Step 4 Run the software.

Step 5 Confirm that the correct serial port and the correct monitor type are set. For details, see “2-9-4-2 Serial Port” and “2-9-4-3 Recorder Type”.

The software is now ready to:

♦Retrieve data from the monitor. See “2-7-1 Retrieving Data from the Monitor”.

♦Clear the monitor’s memory. See “2-7-2 Clearing the Monitor’s Memory”.

♦Program the monitor’s intervals and conditions. See “2-7-3 Programming the Monitor’s Intervals and Conditions”.

8