SECTION 5—WHEELCHAIR OPERATION
Mode Switch
The mode switch is used to select the operating mode for the wheelchair. The mode switch is located on the joystick. A mode switch is needed whenever any of the following operating modes are programmed:
•Environmental Controls (ECU 1, ECU 2, ECU 3, ECU 4)*
•3 Speed Mode in Digital 3 Speed (Slow, Medium, Full)
•Latched Modes
•Sleep Mode
•RIM Mode*
•Remote Drive Selection Mode*
•Tilt/Recline Mode*
•Information Center Display Selection (does not require Reset activation at power up)
If any of the above modes are selected, the control will require activation of the switch immediately after the power switch is turned On in order to enter the drive mode. The second line of the LCD will display - PRESS RESET.
*NOTE: In these modes, Standby Select allows the reset switch to be bypassed for users unable to activate the switch.
Memory Card Slot
The memory card slot is used with the basic or professional memory card for saving or reading wheelchair parameters.
Preparing the Joystick for Use
NOTE: For this procedure, refer to FIGURE 5.8.
NOTE: The joystick is factory installed on the right side of the wheelchair. To reposition the joystick onto the left side of the wheelchair, refer to Repositioning the Joystick on page 34.
1.Turn the adjustment lock lever to release the adjustment lock from joystick mounting tube.
2.Slide joystick mounting tube to the desired position.
3.Turn the adjustment lock lever to secure the adjustment lock to the joystick mounting tube.
NOTE: Joystick not shown.
Joystick Mounting
Tube
Adjustment
Lock Lever
FIGURE 5.8 Preparing the Joystick for Use
Part No 1122170 | 33 | Formula™ Powered Seating |