Invacare Powered Seating manual Adjusting the Tension of the Flip Up Footplate, Before 2/15/07

Page 49

SECTION 6—FRONT RIGGINGS

Before 2/15/07

NOTE: For this procedure, refer to FIGURE 6.19.

1.Loosen the footplate mounting screw and move the footplate to the desired angle.

NOTE: DO NOT remove the footplate mounting screw.

2.Tighten the footplate mounting screw to secure the footplate in the desired position.

3.Repeat STEPS 1 and 2 for the other footplate.

Center Mount

Footrest

Footplate

Footplate Mounting

Screw

FIGURE 6.19 Adjusting the Footplate

Angle - Before 2/15/07

Adjusting the Tension of the Flip Up Footplate

NOTE: For this procedure, refer to FIGURE 6.20.

NOTE: This procedure applies to both power and manual center mount footrests.

NOTE: The tension can be adjusted to increase or decrease the rotation effort of the flip up footplates.

1. Loosen the mounting screw on the footrest angle hinge to decrease the rotation effort. NOTE: DO NOT remove the footplate mounting screw.

2.Tighten the footrest angle hinge mounting screw to increase the rotation effort.

3.Repeat STEPS 1 and 2 for the other footplate.

Center	Footplate
Center
Mount
Footrest

Footrest

Angle

Hinge

Footrest Angle

Hinge Mounting

Screw

FIGURE 6.20 Adjusting the Tension of the Flip Up Footplate

Part No 1122170

49

Formula™ Powered Seating

Image 49

Contents Dealer This manual Must be given to the user of the product Formula Powered SeatingReference Documents Reference DocumentsDocument Part Number Table of Contents Register Your Product Special Notes Signal Word MeaningWheelchair TIE-DOWN Restraints and Seat Restraints Trbkts Powered Seating System Warnings All Wheelchairs Label LocationsWheelchairs with Elevate Wheelchairs with Ventilator Trays Typical Product Parameters Formula Powered Seating SystemsContoura Backs Conventional Backs Typical Product Parameters Contoura Backs ConventionalGeneral Guidelines Repair or Service InformationOperation Information General Guidelines General Guidelines Weight Limitation Weight TrainingEMI Information EMI InformationEMI Information Pinch Points SAFETY/HANDLING of WheelchairsSafety Inspection Checklists Safety INSPECTION/ TroubleshootingInspect/Adjust Initially Inspect/Adjust Monthly Inspect/Adjust WeeklyInspect/Adjust Periodically Symptom Probable Cause Solutions TroubleshootingJS REV TOO Large Tilt Warning displays Wheelchair Operation System Type Joystick Powered Seating Control Operating Powered Seating SystemsSwitch Option Through Using the Four Way Switch Using the Powered Seating SwitchSeating System Four WAY Switch RightIcon Description Using the MPJ+ joystickUsing the MPJ+ joystick Drive Select Toggle Switch MPJ+ Joystick Switches and IndicatorsSpeed Control Charger/Programming Input JoystickLCD Display Screens LCD Display ECU Remote On/Off Switch Programmable Mono Port 1/2 or External Mode SwitchWheelchair Operation Icon Preparing the Joystick for Use Mode SwitchMemory Card Slot Repositioning the Joystick Front Riggings Installing/Removing FootrestsPHAL4A, 70 and PW93 Taper Footrest Height AdjustmentPHAL4A Front Riggings PW93 Footrest Height Adjustment PW93Raising/Lowering Elevating Front Riggings Adjusting/Replacing Telescoping Front Rigging SupportAdjusting/Replacing Telescoping Front Rigging Support Installing Adjustable Angle Flip-up Footplates Installing Adjustable Angle Flip-up Footplate HingeDepth Adjustment Adjusting Adjustable Angle Flip-Up FootplatesAngle Adjustment Perpendicular and/or Inversion/Eversion AdjustmentDisassembly Composite/Articulating Footplate Heel Loop ReplacementAssembly Installing Installing/Removing Elevating LegrestsRemoving Raising/Lowering Elevating Legrests Adjusting CalfpadsRemoving/Installing the Center Mount Footrest 15 Removing/Installing the Center Mount Footrest 16 Adjusting the Height of the Center Mount Footrest Adjusting the Height of the Center Mount FootrestAdjusting the Footplate Angle Adjusting the Angle of the Manual Center Mount FootrestAfter 2/14/07 Before 2/15/07 Adjusting the Tension of the Flip Up Footplate21 Calf Pad Adjustment for Power Center Mount Footrests Calf Pad Adjustment for Power Center Mount FootrestsHeight and Width Adjustment Installing/Removing the Power Elevating LegrestsInstalling the Power Elevating Legrests 22 Installing/Removing the Power Elevating Legrests Removing the Power Elevating LegrestsArms Installing/Removing Flip Back ArmrestsAdjusting Adjusting Flip Back ArmrestsPositioning Flip Back Armrests for User Transfer Positioning Flip Back Armrests for UseInstalling Armrests Removing/Installing Reclining ArmrestsRemoving Armrests Adjusting Reclining Armrest Height Adjusting Reclining Armrest Height Seat Adjusting the Back AngleReplacing Seat Positioning Strap Replacing Seat Positioning StrapHeadrest Removing/Installing/Adjusting HeadrestAdjusting Headrest Depth/Direction Adjusting Headrest HeightReplacing Headrest Elevate Batteries Replacing Batteries Using the Proper BatteriesElevate Batteries Replacing Batteries Removing/Installing the Batteries From/Into the Wheelchair Cleaning Battery TerminalsRemoving the Battery Door and Rear Shrouds ImmediatelyRemoving the Battery Door and Rear Shrouds Removing the Batteries Installing BatteriesInstalling Batteries Installing the Battery Door and Rear ShroudCharging Batteries When to Charge BatteriesTool Quantity Comments Description and Use of Battery ChargersCharging Batteries Preparing the Ventilator Tray for Use Ventilator TrayPreparing the Ventilator Tray for Use Global Limited Warranty Excluding Canada Global Limited Warranty Excluding CanadaUSA Canada Limited Warranty