Invacare Powered Seating manual Footrest Height Adjustment, Taper, PHAL4A Front Riggings

SECTION 6—FRONT RIGGINGS

70° Taper
			Footrest
NOTE: For this procedure, refer to			Mounting Pin
FIGURE 6.2				Footrest
1.	Turn the footrest to the side (open			Release
		Mounting Tube		Lever
	footplate is perpendicular to
	wheelchair).	Footplate
2.	Insert footrest mounting pin into
	mounting tube.
3.	Push the footrest towards the inside of	FIGURE 6.2 Installing/Removing Footrests -
	the wheelchair until it locks into place.		70° Taper

NOTE: The footplate will be on the inside of the wheelchair when locked in place.

4.Repeat STEPS 1- 3 for the other footrest assembly.

5.To remove the footrest, push the footrest release lever inward, rotate footrest outward.

6.Adjust footrest height, if desired. Refer to Footrest Height Adjustment on page 36.

Footrest Height Adjustment

WARNING

Minimum ground clearance for the footrest is 3 inches - otherwise personal injury or damage may result.

PHAL4A Front Riggings

NOTE: For this procedure, refer to

FIGURE 6.3.

1.Loosen, but DO NOT remove, the lug bolt and locknut that secure the lower footrest to the footrest support.

2.Reposition the lower footrest to the desired height.

3.Securely tighten the lug bolt and locknut that secure the lower footrest to the footrest support.

4.Repeat STEPS 1-3 for the opposite side of the wheelchair footrest, if necessary.

NOTE: PH904A style front rigging shown. PHAL4A front rigging adjust the same way.

Footrest

SupportLocknut

Lower Footrest

Lug Bolt

FIGURE 6.3 Footrest Height Adjustment

Formula™ Powered Seating 36 Part No 1122170