Invacare Powered Seating manual Installing/Removing Elevating Legrests

SECTION 6—FRONT RIGGINGS

Installing/Removing Elevating Legrests

NOTE: For this procedure, refer to FIGURE 6.13.

Installing

1.Turn legrest to side (open footplate is perpendicular to wheelchair).

2.Install the legrest hinge plates onto the hinge pins on the wheelchair frame.

3.Rotate legrest toward the inside of the wheelchair until it locks in place.

NOTE: The footplate will be on the inside of the wheelchair when locked in place.

4. Repeat STEPS 1-3 for the opposite
legrest.	Calfpad
5. After the user is seated in wheelchair,	Hinge Pins
	Legrest
adjust footplate to correct height by
loosening nut and sliding the lower	Hinge Plates
footrest assembly UP or down until
desired height is achieved.

Removing

1.Push the legrest release handle toward the inside of the wheelchair (facing the front of the wheelchair) and swing the legrest to the outside of the wheelchair.

2.Lift UP on the legrest and remove from the wheelchair.

3.Repeat STEPS 1- 2 for opposite side of wheelchair.

Legrest Release Handle

Bolt/Nut

FIGURE 6.13 Installing/Removing Elevating

Legrests

Part No 1122170 43 Formula™ Powered Seating