Invacare Powered Seating manual Front Riggings, Installing/Removing Footrests, PHAL4A, 70 and PW93

SECTION 6—FRONT RIGGINGS

SECTION 6—FRONT RIGGINGS

WARNING

After ANY adjustments, repair or service and BEFORE use, make sure that all attaching hardware is tightened securely - otherwise injury or damage may result.

For the following procedures, make sure the On/Off switch on the joystick is in the OFF position.

DO NOT stand on the flip-up footboard. When getting in or out of the wheelchair, make sure that the flip-up footboard is in the upward position.

PINCH POINT EXISTS BETWEEN CENTER MOUNT FOOTREST AND CASTERS - There is limited clearance between center mount footrest and casters. The user’s feet MUST remain on the center mount footrest while operating the wheelchair. If the user’s feet are allowed to rest off the side of the center mount footrest they may come in contact with the caster possibly resulting in injury.

While the wheelchair is moving, minimum ground clearance for the front rigging is three inches. If the wheelchair is not moving, the front rigging MUST maintain a minimum of one inch ground clearance - otherwise personal injury and damage may result.

Installing/Removing Footrests

PHAL4A, 70° and PW93

NOTE: For this procedure, refer to FIGURE 6.1.

1.Turn the footrest to the side (open footplate is perpendicular to wheelchair).

2.Install the hinge plates on the footrest onto the hinge pins on the wheelchair frame.

Hinge

Pins

Hinge Plate

Footrest

Footrest Release

Lever

3.Push the footrest towards the inside of the wheelchair until it locks into place.

NOTE: The footplate will be on the inside of the wheelchair when locked in place.

FIGURE 6.1 Installing/Removing Footrests -

Phal4A, 70° and pw93

4.Repeat STEPS 1-3 for other footrest assembly.

5.To remove the footrest, push the footrest release lever inward, rotate footrest outward.

6.Adjust footrest height, if desired. Refer to Footrest Height Adjustment on page 36.

Part No 1122170 35 Formula™ Powered Seating