SECTION 1—GENERAL GUIDELINES
ALWAYS turn the wheelchair power Off and engage the motor locks/clutches to prevent the wheels from moving before attempting to transfer in or out of the wheelchair. Also make sure every precaution is taken to reduce the gap distance. Align both casters parallel with the object you are transferring onto.
DO NOT use with a broken or missing joystick knob.
DO NOT use if joystick does not spring back to the neutral position or becomes sticky or sluggish.
DO NOT use if joystick boot is torn or damaged.
ALWAYS check foam grips for looseness before using the wheelchair. If loose, contact a qualified technician for instructions.
ALWAYS engage both wheel locks and reduce the gap distance before transferring to and from the wheelchair. Turn all casters parallel to the object you are transferring onto.
Avoid storing or using the wheelchair near open flame or combustible products. Serious injury or damage to property may result.
Use caution when driving in a tilted, elevated or reclined position.
DO NOT operate the seating system while on an incline.
DO NOT operate the seating system while the wheelchair is moving.
NEVER operate the wheelchair or elevate/lower the seat while in any tilted/reclined/back angle position over 20° relative to the vertical position. If the drive
Use only the controls listed in Operating Powered Seating Systems on page 24 to activate the powered seating functions*. DO NOT USE any other actuator controls. Such devices may result in excess heating and cause damage to the actuator and associated wiring and could cause a fire, death, physical injury or property damage. If such devices are used, Invacare shall not be liable and the limited warranty is void.
*NOTE: Specific actuator controls are noted for each function or combination throughout this manual.
DO NOT operate tilt seat around children.
ALWAYS keep hands and feet out from underneath tilt seat - otherwise serious injury may result.
DO NOT tip the seating system/wheelchair without assistance.
DO NOT store items under seat.
Cables must be routed and secured properly to ensure that cables DO NOT become entangled and damaged during normal operation of seating system.
Systems equipped with power legrests only - NEVER allow items to become trapped between the legrest assemblies. Otherwise, damage to the power legrest could occur.
Part No 1122170 | 13 | Formula™ Powered Seating |