Invacare 1026793 manual Repair and Service Information, Operating Information

Page 13

SECTION 1—GENERAL GUIDELINES

Repair and Service Information

Unless otherwise noted, all service and adjustments should be performed while the wheelchair is unoccupied.

Operating Information

To determine and establish your particular safety limits, practice bending, reaching and transferring activities in several combinations in the presence of a qualified health professional BEFORE attempting active use of the wheelchair.

Anti-tippers MUST be used at all times. When outdoors on wet, soft ground or on gravel surfaces, anti-tippers may not provide the same level of protection against tip over. Extra caution must be observed when traversing such surfaces.

Mounting the front casters on the inside of the wheelchair frame will reduce the stability of the wheelchair. Try various front caster positions to find the safest front caster position for your needs.

DO NOT operate on roads, streets or highways.

DO NOT climb, go up or down ramps or traverse slopes greater than 9°.

DO NOT attempt to move up or down an incline with a water, ice or oil film.

DO NOT attempt to ride over curbs or obstacles. Doing so may cause your wheelchair to turn over and cause bodily harm or damage to the wheelchair.

DO NOT stand on the frame of the wheelchair.

DO NOT attempt to reach objects if you have to move forward in your seat.

DO NOT attempt to reach objects if you have to pick them up from the floor by reaching down between your knees.

DO NOT lean over the top of the back upholstery to reach objects from behind as this may cause the wheelchair and/or seating system (if any) to tip over.

DO NOT shift your weight or sitting position toward the direction you are reaching as the wheelchair and/or seating system (if any) may tip over.

DO NOT tip the wheelchair without assistance.

DO NOT use an escalator to move a wheelchair between floors. Serious bodily injury may occur.

DO NOT use footplates as a platform. When getting in or out of the wheelchair, make sure that the footplates are in the upward position or swing footrests towards the outside of the chair.

Make sure the back is locked securely BEFORE using the wheelchair - otherwise injury can occur.

ALWAYS engage both wheel locks and reduce the gap distance BEFORE transferring to and from the wheelchair. Turn all casters parallel to the object you are transferring onto.

Part No 1026793

13

Xtra™

Image 13
Contents Xtra Xtra Table of Contents Front Riggings Arms Complete and mail the form on the next Register Your ProductCity State/Province Product Registration FormFold here Cut Along Line TIE Down Restraints and Seat Restraints Special NotesLabel Locations Xtra Typical Product ParametersStability General GuidelinesOperating Information Repair and Service InformationGeneral Guidelines Weight Limitation Weight TrainingTire Pressure Stability and Balance SAFETY/HANDLING of WheelchairsCoping with Everyday Obstacles Tipping Curbs TippingDo not tip the wheelchair without assistance Method 1 Wheelchair with Step TubesMethod 2 Wheelchair without Step Tubes StairwaysTransferring To and From Other Seats Transferring To and From Other SeatsAdjusting the Wheelbase for Stability Percentage of Weight DistributionReaching, Bending Backward Reaching, Leaning and Bending ForwardSafety Inspection Checklists Safety INSPECTION/ TroubleshootingInspect/Adjust Initially Inspect/Adjust Weekly Inspect/Adjust Periodically Inspect/Adjust MonthlyMaintenance TroubleshootingSuggested Maintenance Procedures Installing/Removing Installing/Removing/Adjusting the FootrestsAdjusting Front RiggingsInstalling/Removing/Adjusting the Footrests Adjusting 70 MFX Adjusting 70 MFX and 90 FootrestsRaising/Lowering Elevating Legrests Installing Elevating LegrestsInstalling Adjustable Angle Flip-Up Footplate Hinge Adjusting CalfpadsDepth Adjustment Adjusting Adjustable Angle Flip-Up FootplatesAngle Adjustment Installing Impact Guards/Calf Strap Heel Loop ReplacementBack Adjusting the Back HeightDetail a back Adjusting the Back AngleInstalling/Removing the Chest Positioning Strap Installing/Removing the Chest Positioning StrapInstalling and Removing a Seating System Installing the Stroller HandlesFolding/Unfolding the Wheelchair SeatUnfolding FoldingReplacing Seat Upholstery Installing/Removing Seat Positioning StrapInstalling/Removing Seat Positioning Strap Installing Fabric Clothing GuardsInstalling Clothing Guards Installing Clothing GuardsArms Installing the Half ArmInstalling the Half Arm Adjusting Half Arm HeightAdjusting Armrest Height Using/Adjusting Dual Point ArmsRemoving Armrests Replacing ArmrestsInstalling T-Arms Installing/Removing T-ArmsReplacing Dual Point Arm Pad/Clothing Guards Replacing Arm PadAdjusting T-Arm Height Adjusting the T-ArmsRemoving T-Arms Adjusting T-Arm Height Adjusting T-Arm WidthShown for clarity Adjusting T-Arm DepthAdjusting T-Arm Sockets Adjusting T-Arm Sockets10 Adjusting T-Arm Transfer Assists and/or Side Guards Adjusting T-Arm Transfer Assists and/or Side GuardsRemoving/Installing Rear Wheels Repairing/Replacing Pneumatic Tire/TubeWheels Quick-Release AxlesPermanent Axles Removing/Installing Rear WheelsAdjusting Quick-Release Axles Adjusting Quick-Release AxlesInstalling Quad-Release Axles Installing Quad-Release AxlesAnd/or Out Adjusting Quad-Release HandlesRemoving the Play From the Rear Wheels Adjusting Forks Adjusting ForksAdjusting the Wheel Lock Replacing/Adjusting the Wheel LocksWheel LOCKS/ANTI- Tippers Replacing the Wheel LockInstalling Anti-Tippers Installing/Adjusting the Anti-TippersAdjusting Anti-Tippers Installing Amputee Attachments Installing Amputee AttachmentsUSA Limited Warranty