Invacare 1026793 manual Installing Elevating Legrests, Raising/Lowering Elevating Legrests

SECTION 4—FRONT RIGGINGS

Installing Elevating Legrests

NOTE: For this procedure, refer to FIGURE 4.3.

1.Insert the pivot tube into the legrest support and secure it with the bolt and nut.

2.Place legrest on the outside of the wheelchair and insert the mounting pin into the mounting tube.

3.Rotate legrest toward the inside of the wheelchair until it locks in place.

NOTE: The footplate will be on the inside of the wheelchair when locked in place.

4.Repeat STEPS 1-3 for the opposite legrest.

5.After seated in wheelchair, adjust footrest to correct height by loosening nut and sliding the pivot tube up or down until desired height is obtained.

6.To release the legrest, push the legrest release handle toward the inside of the wheelchair and swing the legrest to the outside of the wheelchair.

		Legrest Release Handle
Calfpad
	Pivot Tube	Mounting Pin

Bolt and Nut

Footrest Assembly

Footplate Mounting Tube

FIGURE 4.3 Installing Elevating Legrests

Raising/Lowering Elevating Legrests

NOTE: For this procedure, refer to FIGURE 4.4.

Perform one (1) of the following:

•Raising - Pull back on the release lever until the leg is at the desired height.

•Lowering - Support leg with one (1) hand and push release lever downward with other hand.

Release Lever

FIGURE 4.4 Raising/Lowering Elevating

Legrests

Xtra™ 30 Part No 1026793