Invacare 1026793 manual Replacing Dual Point Arm Pad/Clothing Guards, Installing/Removing T-Arms

SECTION 7—ARMS

Replacing Dual Point Arm Pad/Clothing Guards

NOTE: For this procedure, refer to FIGURE 7.4.

Replacing Arm Pad

1.Remove the phillips screws that secure the arm pad to the armrest assembly.

2.Replace arm pad and securely tighten with the existing phillips screws.

Replacing Clothing Guards

NOTE: This procedure is for fixed height dual point arms ONLY.

	Arm Pad
	Armrest
Screws	Assembly

1. Remove the four (4) screws that secure

the existing clothing guard to the

armrest assembly.

Clothing

Phillips Screws

2.	Replace the existing clothing guard
	with the new clothing guard and
	securely tighten with the existing
	hardware.
3.	Repeat STEPS 1-2 for the opposite side
	if necessary.

Guards

Screws

FIGURE 7.4 Replacing Dual Point Arm Pad/

Clothing Guards

Installing/Removing T-Arms

NOTE: For this procedure, refer to FIGURE 7.5.

Installing T-Arms

1. Position the T-arm over the T-arm socket on the wheelchair frame.

NOTE: Make sure the locking lever is towards the front of the wheelchair.

2.Slide T-arm into T-arm socket until the locking lever is in the slot in the T-arm socket and an audible "click" is heard.

3.Pull up on T-arm to make sure T-arm is locked in place.

NOTE: If the T-arm does not slide in the T-arm socket as desired, adjust the T-arm socket. Refer to Adjusting the T-Arms on page 46.

4.Adjust the T-arm for desired height, width and depth, if necessary. Refer to Adjusting the T-Arms on page 46.

5.Repeat STEPS 1-4 for opposite side of wheelchair.

Part No 1026793 45 Xtra™