Invacare 1026793 manual Adjusting the Back Angle, Detail a back

SECTION 5—BACK

Adjusting the Back Angle

NOTE: For this procedure, refer to FIGURE 5.2.

NOTE: This procedure applies to adjustable angle backs only.

NOTE: The back adjusts to four (4) positions in five 5° degree increments from 0° to 15°.

1.Remove the two (2) back angle adjustment screws and locknuts.

2.Reposition the back to the desired angle.

3.Ensure the upper back angle mounting hole is aligned with one (1) of the four (4) upper angle adjustment holes.

4.Install one (1) of the back angle adjustment screws through the upper back angle mounting hole and the desired upper angle adjustment hole.

5.Install the remaining back angle adjustment screw through the lower back angle mounting hole and the desired lower angle adjustment hole.

6.Secure each back angle adjustment screw with a locknut. Torque locknut to 80-100 in/ lbs.

Back Cane	Upper Back Angle
	Mounting Hole	Detail "A" - back
Back Angle
		angle mounting holes
Adjustment
Screw		Upper
	Locknut
		0°
Locknut		5°
		10°
		15°
		Lower
		0°
Lower Back	Back Angle	5°
		10°
Angle Mounting	Adjustment
		15°
Hole	Screw

FIGURE 5.2 Adjusting the Back Angle

Part No 1026793 35 Xtra™