Invacare 1026793 manual Stairways, Method 2 Wheelchair without Step Tubes

Page 19

SECTION 2—SAFETY/HANDLING OF WHEELCHAIRS

The first assistant should stand on the sidewalk and turn the wheelchair so that the rear wheels are against the curb. The wheelchair should be tilted back to the balance point and, in one continuous downward movement, the rear wheels should be pulled up and over the curb. DO NOT return the front casters to the ground until the wheelchair has been pulled backward far enough for the front casters to clear the edge of the curb.

FIGURE 2.2 Method 2 - Wheelchair without Step Tubes

Stairways

WARNING

DO NOT attempt to lift a wheelchair by lifting on any removable (detachable) parts. Lifting by means of any removable (detachable) parts of a wheelchair may result in injury to the user or damage to the wheelchair.

Extreme caution is advised when it is necessary to move an occupied wheelchair up or down the stairs. Invacare recommends that, if possible, the user be removed from the wheelchair prior to moving. Invacare recommends using two (2) assistants and making thorough preparations. Make sure to use only secure, non-detachable parts for hand-held supports.

ALWAYS wear your seat positioning strap. Inasmuch as the SEAT POSITIONING STRAP is an option on this wheelchair (you may order with or without the seat positioning strap), Invacare strongly recommends ordering the seat positioning strap as an additional safeguard for the wheelchair user.

The seat positioning strap is a positioning belt only. It is not designed for use as a safety device withstanding high stress loads such as auto or aircraft safety belts. If signs of wear appear, the strap MUST be replaced immediately.

Follow this procedure for moving the wheelchair between floors when an elevator is NOT available:

1.If so equipped, rotate the anti-tippers so the wheels are facing up.

2.After the wheelchair has been tilted back to the balance point, one assistant (in the rear) backs the wheelchair up against the first step, while securely grasping a non- removable (non-detachable) part of the wheelchair for leverage.

Part No 1026793

19

Xtra™

Image 19
Contents Xtra Xtra Table of Contents Front Riggings Arms Complete and mail the form on the next Register Your ProductCity State/Province Product Registration FormFold here Cut Along Line TIE Down Restraints and Seat Restraints Special NotesLabel Locations Xtra Typical Product ParametersStability General GuidelinesOperating Information Repair and Service InformationGeneral Guidelines Weight Limitation Weight TrainingTire Pressure Stability and Balance SAFETY/HANDLING of WheelchairsCoping with Everyday Obstacles Method 1 Wheelchair with Step Tubes TippingTipping Curbs Do not tip the wheelchair without assistanceMethod 2 Wheelchair without Step Tubes StairwaysTransferring To and From Other Seats Transferring To and From Other SeatsAdjusting the Wheelbase for Stability Percentage of Weight DistributionReaching, Bending Backward Reaching, Leaning and Bending ForwardSafety Inspection Checklists Safety INSPECTION/ TroubleshootingInspect/Adjust Initially Inspect/Adjust Weekly Inspect/Adjust Periodically Inspect/Adjust MonthlyMaintenance TroubleshootingSuggested Maintenance Procedures Front Riggings Installing/Removing/Adjusting the FootrestsInstalling/Removing AdjustingInstalling/Removing/Adjusting the Footrests Adjusting 70 MFX Adjusting 70 MFX and 90 FootrestsRaising/Lowering Elevating Legrests Installing Elevating LegrestsInstalling Adjustable Angle Flip-Up Footplate Hinge Adjusting CalfpadsDepth Adjustment Adjusting Adjustable Angle Flip-Up FootplatesAngle Adjustment Installing Impact Guards/Calf Strap Heel Loop ReplacementBack Adjusting the Back HeightDetail a back Adjusting the Back AngleInstalling/Removing the Chest Positioning Strap Installing/Removing the Chest Positioning StrapInstalling and Removing a Seating System Installing the Stroller HandlesFolding SeatFolding/Unfolding the Wheelchair UnfoldingReplacing Seat Upholstery Installing/Removing Seat Positioning StrapInstalling/Removing Seat Positioning Strap Installing Fabric Clothing GuardsInstalling Clothing Guards Installing Clothing GuardsArms Installing the Half ArmInstalling the Half Arm Adjusting Half Arm HeightReplacing Armrests Using/Adjusting Dual Point ArmsAdjusting Armrest Height Removing ArmrestsReplacing Arm Pad Installing/Removing T-ArmsInstalling T-Arms Replacing Dual Point Arm Pad/Clothing GuardsAdjusting T-Arm Height Adjusting the T-ArmsRemoving T-Arms Adjusting T-Arm Height Adjusting T-Arm WidthShown for clarity Adjusting T-Arm DepthAdjusting T-Arm Sockets Adjusting T-Arm Sockets10 Adjusting T-Arm Transfer Assists and/or Side Guards Adjusting T-Arm Transfer Assists and/or Side GuardsQuick-Release Axles Repairing/Replacing Pneumatic Tire/TubeRemoving/Installing Rear Wheels WheelsPermanent Axles Removing/Installing Rear WheelsAdjusting Quick-Release Axles Adjusting Quick-Release AxlesInstalling Quad-Release Axles Installing Quad-Release AxlesAnd/or Out Adjusting Quad-Release HandlesRemoving the Play From the Rear Wheels Adjusting Forks Adjusting ForksReplacing the Wheel Lock Replacing/Adjusting the Wheel LocksAdjusting the Wheel Lock Wheel LOCKS/ANTI- TippersInstalling Anti-Tippers Installing/Adjusting the Anti-TippersAdjusting Anti-Tippers Installing Amputee Attachments Installing Amputee AttachmentsUSA Limited Warranty