Invacare 1026793 manual Adjusting T-Arm Depth, Shown for clarity

SECTION 7—ARMS

Adjusting T-Arm Depth

NOTE: For this procedure, refer to FIGURE 7.8.

1.Remove the two (2) phillips screws that secure the arm pad to the arm tube.

2.Remove the two (2) socket screws that secure the arm tube to the T-arm post.

3.Reposition the arm tube on the T-arm post:

•Desk Length Arms - to one (1) of three (3) positions depending on the desired arm pad depth.

•Full Length Arms - to one (1) of five (5) positions depending on the desired arm pad depth.

NOTE: Additional positions are obtainable by turning the arm tube 180°.

4.Re-secure the arm tube to the T-arm post with the two (2) socket screws. Torque to 60- 70 in./lbs.

5.Reattach the arm pad to the arm tube with the two (2) phillips screws. Tighten securely.

6.Repeat for the opposite side, if necessary.

NOTE: Desk length arm
shown for clarity.	Arm Pad
	Arm Tube
Socket	NOTE: If
	necessary, turn
	arm tbue 180°
Phillips	to obtain two
	(2) positions.
Screw
T-Arm	Phillips Screw

FIGURE 7.8 Adjusting T-Arm Depth

Xtra™ 48 Part No 1026793