Kirby appendix Kirby Morgan 37 Assembly, SuperFlow 450 Regulator, Regulator Body, 112

7.12.6 Assembly of the

1) Inspect the interior of the regulator body and make

SuperFlow 450 Regulator

sure that it is clean and there is no foreign matter.

Required Tools:

11/16 inch Open-end Attachment on Torque

2) Install the o-ring into the regulator body.

Wrench

7/8 inch Open-end Wrench, Torque Wrench and 1

3) Place the exhaust valve insert in the regulator body.

3/8 inch Socket

The insert must be oriented so that it seals against

1 /4 inch Flat Blade Attachment on Torque Screw-

the o-ring and the exhaust valve will mate properly

driver

with the insert.

4) Use a flat blade screwdriver to push the retainer clip

into the opening in the regulator body for the exhaust

valve insert. The clip should lock into place.

5) Install the exhaust valve into the exhaust valve

insert. Cut off any excess tail from the exhaust valve

that protrudes into the regulator body.

To test to see if the insert is installed properly, try to

spin the insert. It should not turn. You should not be

able to dislodge the insert by hand. Friction between

the insert, the o-ring and the regulator body should

hold the insert in its proper position.

Install the o-ring and valve insert.

o-ring

Install the retainer clip.

SuperFlow 450 exhaust valve mechanism.

112

© Copyright 1970-2008 Kirby Morgan Dive Systems, Inc. All rights reserved. Document # 080508001