Kirby 37 appendix Ring, Details of the SuperFlow 450 main tube and associated parts, 111

Kirby Morgan 37 & 57

	o-ring
	Balance
Inlet valve	spacer
	Spring
Main tube
Bearing	Seat
clip

Lever

o-ring

o-ring

Adjustment nipple

8)Remove the adjustment shaft from the flex knob. With the shaft out, grab the packing nut with one hand and the flex knob with the other and bend. There is a boss on the knob that will pop loose from the packing nut.

9)Remove the o-rings from the adjustment shaft and packing nut.

10)Remove the lever by gently pulling one leg out from the slot on the main tube, followed by the sec- ond leg.

9)Remove the bearing clip from the main tube.

10)Slide the balance spacer, spring, inlet valve as- sembly out from the main tube.

11)Unscrew the adjustment nipple from the main tube.

12)Remove the o-ring from the balance spacer.

13)Remove the o-ring from the main tube.

14)Unscrew the adjustment nipple from inside the

Details of the SuperFlow 450 main tube and associated parts.

main tube and remove the o-ring from the nipple.

15)Remove the retainer ring from the regulator body.

16)Remove the exhaust valve insert from the regu- lator body and separate the exhaust valve from the insert.

17)Inspect all parts for signs of wear or damage and replace if necessary.

18)Clean all parts per chapter 6. Lubricate o-rings and moving parts with a light coating of Christo- Lube®.

© Copyright 1970-2008 Kirby Morgan Dive Systems, Inc. All rights reserved. Document # 080508001 111