Intended Use
The Hair Straightener is intended for the smoothing and shaping of human hair, under no circumstances may it to be used for wigs and hairpieces made of syn- thetic material. The Hair Straightener is intended for domestic use only. Pay heed to the information in this operating manual, especially the safety instructions.
Placing/Fixing
the combination mounting
You can either securely place the combination a mounting or fix it to the wall.
Setup
Place the combination mounting a on a level, dry and heat resistent surface.
Items supplied
•Hair Straightener KH 5525
•Combination mounting
•2 narrow ceramic plates
•2 wide ceramic plates
•Screws
•Wall plugs
•Warranty card
•Operating manual
Appliance description
q Control lamp/Viewing window for temperature adjustment
w On/Off switch
e Power cable with plug
r Rotary controller temperature adjustment t Ceramic plate narrow
y Ceramic plate wide
u Securing holes for
o Retainer for ceramic plates a Combination mounting
Wall mounting
Danger!
Ensure that there are no electric cables, gas and water pipelines or other facilities located underneath the position at which you might wish to affix the combination mounting a. There is a risk of receiving an injury or an electric shock should you bore holes at these posi- tions!
1.Mark the boreholes on the wall.
To do this hold the combination mounting a at the desired position and, with a pencil or a sharp object, mark the drilling locations through the securing holes u.
Take note that the markings need to be made through the upper, smaller part of the securing holes u.
2.Bore holes at the marked positions and insert the wallplugs into them.
3.Turn the screws so far into the wallplugs that ca. 5 mm of the screwshafts continue to be ex- posed.
4.Place the combination mounting a over the screws so that they protrude through the secu- ring holes u.
5.Press the combination mounting a down so that the screwshafts are now in the narrow part of the securing holes u.
6.Tighten both screws down.
- 3 -