Replacing Belt
+ |
+
Felt Packing | Lift Agitator Up | |
Unidad del agitador | ||
Empaquetadura | ||
Soulever l'agitateur | ||
de fieltro | ||
| ||
Cale en feutre |
| |
| + | |
Motor Shaft | Install | |
Eje del motor | ||
New Belt | ||
Arbre d'entraînement | ||
Instalación | ||
du moteur | ||
de la correa | ||
| ||
| Poser la | |
| nouvelle courroie |
+ 
+
+
Groove | End Cap |
Ranura | Tapa del extremo |
Rainure | Bouchon |
➢Replace belt whenever a burning rubber smell caused by excessive slippage occurs.
➢Remove lower plate.
➢Lift rear belt cover and remove felt packing.
➢Remove agitator by carefully lifting out.
➢Remove worn or broken belt.
➢Clean agitator.
➢Loop new belt (Panasonic Type UB8 only) around motor shaft and agitator pulley; see illustration for correct belt routing.
➢Reinstall agitator back into nozzle housing grooves.
➢Close rear belt cover and reinstall felt packing.
➢After reinstalling the agitator, turn it by hand to make sure that belt is not twisted or pinched and that all rotating parts turn freely.
➢Reinstall lower plate.
Cleaning Agitator
➢ Clean agitator after every five uses and every time the belt is replaced.
➢ Remove lower plate.
➢ Cut off any carpet pile and lint entangled around agitator with a pair of scissors.
➢Remove agitator.
➢Remove any string or debris located on the end caps, washers or agitator shaft.
➢Reinstall agitator and lower plate.
- 32 -