3Release buttons
4Switch with incorporated SmartLight
5Socket for cord connector
6Cord connector
712 V transformer plug
8Precision head
9Facial cleansing wipes
10Cooling application
(gel pack (a), cooling glove (b))
Before starting
Preparing your skin
Your skin must be dry and free from grease or cream.
Optional skin cooling: For the first few epilations or if you have sensitive skin you can use the cooling application, recom- mended by dermatologists to help reduce possible skin irritation.
•Ensure that the gel pack has been in the deep freezer (***) for at least 2 hours (for convenience you can store the gel pack in the freezer).
•Insert the gel pack underneath the glove’s transparent foil. Use only with glove.
•Put transparent (cool) side of the glove on your leg.
•Start cooling for approx. 1/2 minute, longer if needed.
•Epilate the cooled skin area immedi- ately as described in section «How to epilate».
•Repeat cooling and epilating until completion.
•While epilating, please ensure your skin is dry.
Important: Apply cooling glove to the same area for no longer than 2 minutes. Keep away from sunlight. Do not use gel pack when damaged. Dispose of in household waste. Do not use if you are hypersensitive, allergic to the cold, or
if your skin suffers from sensory disturb- ances, when suffering from cardiac dis- eases or arterial circulatory disorders.
Preparing the appliance
•Before starting off, thoroughly clean
the epilation head you want to use (B or b).
•To remove the epilation head, press the release buttons 3 on the left and right and pull it off.
•Click the desired head into place:
–Choose the starter epilation head b if you are epilating for the first time or if you have very sensitive skin.
–Once your skin is used to epilation,
you may switch to the standard epi- lation head B which allows a more efficient and faster epilation thanks to its greater number of tweezers.
Plug the cord connector 6into the socket
5and plug the transformer plug 7 into an electrical outlet.
How to epilate
1Make sure one of the clips A or a is attached to the epilation head.
To turn on the appliance, slide switch 4to the «optimal» setting. For reduced speed, choose the «soft» setting. The SmartLight illuminates as long as the appliance is switched on.
2Rub your skin to lift short hairs. For optimum performance hold the appliance at a right angle (90°) against your skin. Guide it in a slow, continuous movement without pressure against the hair growth, in the direction of the switch.
As hair can grow in different directions, it may also be helpful to guide the appliance in different directions to achieve optimum results.
8