2 12 1
1
2
k c o l
c i t a m o t u a
3
12
press again:
–to display the key part number for shaver foil and cutter block
hold for 3 secs:
–to run a display demo
The SmartLogic inside your shaver will detect when the shaver needs to be cleaned (refer to paragraph «Manual cleaning» or to separate «Clean&Charge» use instructions). To reset the display, push the info key.
The SmartLogic inside will recognize when the shaver has to be lubricated (refer to paragraph «Manual cleaning» or to separate «Clean&Charge» use instructions). To reset the display, push the info key.
The shaver cannot be charged if the environmental temperature is too low (<0 °C) or too high (>55 °C). Allow the shaver to remain for some time at room temperature for optimal charging conditions.
No display: The rechargeable battery is completely discharged and has to be recharged.
Shaving
Switch positions
0 = Off (switch is locked)
Press and push up the switch to operate the shaver 1 = Shaving with the pivoting head
The pivoting cutting system automatically adjusts to every contour of your face
2 = Shaving with the pivoting head locked at an angle (to permit shaving in difficult areas, e.g. under the nose)
3 = The long hair trimmer is activated
(for trimming sideburns, moustache and beard)
Shaving with the cord
If the rechargeable battery is discharged, you may also shave with the shaver connected to the mains via the power supply cord set.
(If the shaver does not run immediately, charge it with the switch on position «0» for approx. 1 minute.)