Genie Z-80, Z-60 manual 2221

Page 11

First Edition · Third Printing	Operator's Manual

CONTROLS

11

12

13

14

23

15

16

17

18

19

20

2221

15Used for optional equipment

16Gasoline/LPG models: Gasoline/LPG select button with indicator lights

17Fault indicator light

18Low fuel indicator light

19Check engine indicator light

20Red Emergency Stop button

21Power indicator light

22Dual axis proportional control handle for drive and steer functions

OR Proportional control handle for drive function and thumb rocker for steer function

23Single axis proportional control handle for secondary boom up/extend and down/retract function

24Single axis proportional control handle for primary boom extend/retract function

25Drive enable button with indicator light

26Dual axis proportional control handle for primary boom up/down and turntable rotate left/right functions

27Jib boom up/down toggle switch

Part No. 82258

Genie Z-80/60

9

Image 11

Contents Operator’s Manual Contact us ContentsDo Not Operate Unless Safety RulesTip-over Hazards Electrocution HazardsSafety Rules Collision Hazards Fall HazardsExplosion and Fire Hazards Component Damage HazardsDecal Legend Damaged Machine HazardsBodily Injury Hazard Ground Control Panel ControlsPlatform Control Panel 2221 Fundamentals Pre-operation InspectionPRE-OPERATION Inspection Pre-operation InspectionCheck the Engine Oil Level MaintenanceObserve and Obey Deutz F4L 913 Engine Engine oil viscosity requirements Check the Hydraulic Oil LevelCheck the Engine Coolant Level Liquid Cooled Models Scheduled MaintenanceCheck the Batteries Test the Machine Functions Function TestsAt the Ground Controls Test Emergency StopTest the Operating Envelope Test Auxiliary ControlsTest the Tilt Sensor At the Platform Controls Test the Steering models with 2 wheel steer Test the Steering models with 4 wheel steerTest the Oscillate Axle Oscillating axle-equipped models Test the Drive Enable SystemTest Drive and Braking Test Limited Drive Speed Workplace Inspection Workplace InspectionOnly use the machine as it was intended Operating InstructionsStarting the Engine Emergency StopOperation from Platform Auxiliary ControlsOperation from Ground Regulated Generator if equipped Drive EnableEngine Idle Select rpm To DriveAfter Each Use Operating Envelope Indicator LightsCheck Engine Light Stopping the EngineDecal Inspection DecalsDecals Transport and Lifting Instructions Free-wheel Configuration for WinchingSecuring the Platform Securing to Truck or Trailer for TransitSecuring the Chassis Turntable Chassis Lifting Point Points Lifting Instructions80/60 Specifications80/60 Range of Motion +34